Porosity measurement of electroless Ni–P coatings reinforced by CNT or SiC particles
- 1 July 2012
- journal article
- Published by SAGE Publications in Surface Engineering
- Vol. 28 (6) , 400-405
Abstract
Ni–P composite coatings containing SiC nanoparticles or carbon nanotubes (CNTs) were deposited on steel substrates via electroless plating technique. An electrochemical polarisation technique was employed to measure the porosity of Ni–P and composite coatings in as plated condition. The technique was based on the changes observed in the corrosion potential with varying cathode and/or anode area on a bimetallic corroding system. Electrochemical impedance spectroscopy (EIS) test was used to assess the corrosion resistance of the coatings. Results showed that incorporation of nanoscaled second phases could decrease the area fraction of porosity from 2··5×10−5 for Ni–P coating to 2×10−7 for Ni–P–CNT coating. Ni–P–CNT coating exhibited the least porosity that it could be attributed to the morphology of CNTs and their ability to fill out the pores more effectively as compared to SiC nanoparticles. EIS results were in agreement with the porosity results as Ni–P–CNT coatings illustrated the highest corrosion resistance.Keywords
This publication has 35 references indexed in Scilit:
- Effect of surfactant on the fabrication and characterization of Ni-P-CNT composite coatingsJournal of Alloys and Compounds, 2011
- Electrochemical studies on electroless ternary and quaternary Ni–P based alloysElectrochimica Acta, 2006
- Effect of particle size on the co-deposition of diamond with nickel in presence of a redox-active surfactant and mechanical property of the coatingsDiamond and Related Materials, 2006
- The fabrication and corrosion behavior of electroless Ni–P-carbon nanotube composite coatingsMaterials Research Bulletin, 2005
- Corrosion behavior of carbon nanotubes–Ni composite coatingSurface and Coatings Technology, 2005
- Effect of alumina content on surface morphology and hardness of Ni-P-Al2O3(α) electroless composite coatingsSurface and Coatings Technology, 2004
- The application of an electrochemical technique to determine the porosity of electroless nickel coatings produced in hypophosphite bathsAnti-Corrosion Methods and Materials, 2003
- Comparison of electrochemical porosity test methods for TiN-coated stainless steelSurface and Coatings Technology, 2002
- Microstructural development of Al–15wt.%Mg2Si in situ composite with mischmetal additionMaterials Science and Engineering: A, 2000
- Porosity of Electrodeposited Coatings: Its Cause, Nature, Effect and ManagementCorrosion Reviews, 1992