Human elbow joint angle estimation using electromyogram signal processing
Authors:
- 16 December 2011
- journal article
- Published by Institution of Engineering and Technology (IET) in IET Signal Processing
- Vol. 5 (8) , 767-775
Abstract
This study proposes a real-time joint angle estimation method of human elbow by processing a biomedical signal of surface synergistic EMG (electromyogram) measured between biceps brachii and triceps brachii simultaneously. Actually, the EMG is known as a non-stationary signal, but the authors assume that it is quasi-stationary because a physical or physiological system has limitations in the rate at which it can change its characteristics. Based on the assumption, a pre-processing method to obtain pre-angle values from the raw synergistic EMG signal is firstly suggested, and then a method to estimate the joint angle through normalisation when there are external loads is discussed. In addition, an optimisation method to minimise the error between the normalised angle and real joint angle is proposed. Finally, the authors show the effectiveness of the suggested algorithm through experimental results.Keywords
This publication has 18 references indexed in Scilit:
- Towards an EMG-Controlled Prosthetic Hand Using a 3-D Electromagnetic Positioning SystemIEEE Transactions on Instrumentation and Measurement, 2007
- Levenberg-Marquardt Based Neural Network Control for a Five-fingered Prosthetic Hand2006
- Hill-Based Model as a Myoprocessor for a Neural Controlled Powered Exoskeleton Arm - Parameters Optimization2006
- A neural network model for reconstructing EMG signals from eight shoulder muscles: Consequences for rehabilitation robotics and biofeedbackJournal of Biomechanics, 2006
- A human-assisting manipulator teleoperated by EMG signals and arm motionsIEEE Transactions on Robotics and Automation, 2003
- Biomedical Signal Analysis2001
- Multireference adaptive noise canceling applied to the EEGIEEE Transactions on Biomedical Engineering, 1997
- The control of a prosthetic arm by EMG pattern recognitionIEEE Transactions on Automatic Control, 1984
- An Algorithm for Sequential Signal Estimation and System Identification for EMG SignalsIEEE Transactions on Biomedical Engineering, 1984
- Adaptive noise cancelling: Principles and applicationsProceedings of the IEEE, 1975