Polymer-assisted deposition of homogeneous metal oxide films to produce nuclear targets
Authors:
- Mazhar N AliMAMazhar N Ali
- Mitch A GarciaMGMitch A Garcia
- T Parsons-MossTPT Parsons-Moss
- Heino NitscheHNHeino Nitsche
- 22 July 2010
- journal article
- Published by Springer Nature in Nature Protocols
- Vol. 5 (8) , 1440-1446
Abstract
Targets are essential in experimental nuclear sciences as a source of stationary nuclei for nuclear reactions with ion beams. Typically, targets should be chemically pure, uniform, homogeneous and crack-free over the irradiation area, while also being structurally rigid. The polymer-assisted deposition (PAD) method uses a water-soluble multidentate polymer that chelates metal precursors in solution. This polymer-metal solution is then spin coated and annealed to yield a crack-free, homogeneous metal oxide film. In this protocol, nuclear targets are created using PAD on silicon nitride (Si(3)N(4)) windows with silicon frames. Silicon wafers ([100], single-side polished) coated with 1 microm of silicon nitride on both sides are patterned and etched to create 1-microm silicon nitride windows. The PAD solution is then spun onto the silicon nitride window and annealed to create a thin, uniform metal oxide film of variable thickness on top of the silicon nitride backing. The production of a target window and the deposition of a thin film ranging from 50 to 150 nm takes approximately 13.5 h. Subsequent reapplications to grow thicker films require an additional 5 h per application.Keywords
This publication has 21 references indexed in Scilit:
- Independent Verification of Element 114 Production in theReactionPhysical Review Letters, 2009
- Metal oxide films produced by polymer-assisted deposition (PAD) for nuclear science applicationsThin Solid Films, 2008
- Heaviest nuclei from48Ca-induced reactionsJournal of Physics G: Nuclear and Particle Physics, 2007
- Green luminescent zinc oxide films prepared by polymer-assisted deposition with rapid thermal processThin Solid Films, 2005
- Epitaxial growth of Eu2O3 thin films on LaAlO3 substrates by polymer-assisted depositionApplied Physics Letters, 2004
- Polymer-assisted deposition of metal-oxide filmsNature Materials, 2004
- Spin coating from a molecular point of view: its concentration regimes, influence of molar mass and distributionMaterials Research Innovations, 2003
- Anisotropic Etching of Crystalline Silicon in Alkaline Solutions: I . Orientation Dependence and Behavior of Passivation LayersJournal of the Electrochemical Society, 1990
- Techniques used at Harwell in the preparation of stable and active nuclide targetsNuclear Instruments and Methods, 1972
- Mass Transfer, Flow, and Heat Transfer About a Rotating DiskJournal of Heat Transfer, 1960