Minimum design metal temperature of Q345R determined by exemption curve in ASME VIII-2 and its derived methods
- 2 December 2021
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
- Vol. 236 (2) , 535-545
Abstract
In order to prevent the brittle fracture accident, minimum design metal temperature of ferrite steel should be limited. After the minimum design metal temperature curve in American Society of Mechanical Engineers VIII-2 (2007) was proposed, much related research has been done in recent years. In this paper, firstly the theoretical basis of four methods used to determine the minimum design metal temperature was introduced. Secondly, the mechanical properties of Q345R was measured by tensile test, Charpy v-notch impact test and fracture toughness test Thirdly, minimum design metal temperature curve of Q345R that determined by four methods were obtained. There are obvious difference between the curves of Q345R that determined by four methods. It can be concluded that low temperature fracture toughness of Q345R is underestimated when classifying Q345R into exemption curve A in American Society of Mechanical Engineers VIII-2 (2007).Keywords
Funding Information
- supported by Anhui Provincial Natural Science Foundation (2008085QE280)
This publication has 12 references indexed in Scilit:
- Estimation of fracture toughness of 16MnDR steel using Master Curve method and Charpy V-notch impact energyTheoretical and Applied Fracture Mechanics, 2018
- Experimental study on the minimum design metal temperature of Q345R steelJournal of Zhejiang University-SCIENCE A, 2018
- Influence of carbide particles on crack initiation and propagation with competing ductile-brittle transition in ferritic steelTheoretical and Applied Fracture Mechanics, 2017
- Structural integrity assessments of steam generator tubes using the FAD methodologyNuclear Engineering and Design, 2015
- Correlations between Charpy V-notch impact energy and fracture toughness of nuclear reactor pressure vessel (RPV) steelsEngineering Fracture Mechanics, 2015
- Applicability of the ASME Exemption Curve for Chinese Pressure Vessel Steel Q345RJournal of Pressure Vessel Technology, 2015
- Failure pressure prediction of a cracked compressed natural gas (CNG) cylinder using failure assessment diagramJournal of Natural Gas Science and Engineering, 2014
- Technical Basis of Material Toughness Requirements in the ASME Boiler and Pressure Vessel Code, Section VIII, Division 2Journal of Pressure Vessel Technology, 2012
- ASME Boiler & Pressure Vessel Code Requirements for Prevention of Brittle FractureJournal of Pressure Vessel Technology, 2003
- An empirical stress-intensity factor equation for the surface crackEngineering Fracture Mechanics, 1981