An 18 V Input 10 MHz Buck Converter With 125 ps Mixed-Signal Dead Time Control
Authors:
- 4 May 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 51 (7) , 1705-1715
Abstract
A highly integrated synchronous buck converter with a predictive dead time control for input voltages >18 V with 10 MHz switching frequency is presented. A high resolution dead time of ~125 ps allows to reduce dead time dependent losses without requiring body diode conduction to evaluate the dead time. High resolution is achieved by frequency compensated sampling of the switching node and by an 8 bit differential delay chain. Dead time parameters are derived in a comprehensive study of dead time depended losses. This way, the efficiency of fast switching DC-DC converters can be optimized by eliminating the body diode forward conduction losses, minimizing reverse recovery losses and by achieving zero voltage switching. High-speed circuit blocks for fast switching operation are presented including level shifter, gate driver, PWM generator. The converter has been implemented in a 180 nm high-voltage BiCMOS technology. The power losses were measured to be reduced by up to 31% by the proposed dead time control, which results in a 5.3% efficiency increase at V IN =18 V, V OUT =5 V, and 0.45 A load. At V IN =12 V, the peak efficiency is 81.2% with an efficiency improvement of 6% with dead time control.Keywords
This publication has 14 references indexed in Scilit:
- Design and Analysis of a High-Efficiency High-Voltage Class-D Power Output StageIEEE Journal of Solid-State Circuits, 2014
- An 84.7% Efficiency 100-MHz Package Bondwire-Based Fully Integrated Buck Converter With Precise DCM Operation and Enhanced Light-Load EfficiencyIEEE Journal of Solid-State Circuits, 2013
- Nanosecond Delay Floating High Voltage Level Shifters in a 0.35 $\mu$m HV-CMOS TechnologyIEEE Journal of Solid-State Circuits, 2010
- Switching losses analysis in MHz integrated synchronous Buck converter to support optimal power stage width segmentation in CMOS technology2010
- Area- and Power-Efficient Monolithic Buck Converters With Pseudo-Type III CompensationIEEE Journal of Solid-State Circuits, 2010
- Dynamic dead-time controller for synchronous buck DC-DC convertersElectronics Letters, 2010
- Zero-Voltage-Switching Control for a PWM Buck Converter Under DCM/CCM BoundaryIEEE Transactions on Power Electronics, 2009
- A gm-C Ramp Generator for Voltage Feedforward Control of DC-DC Switching Regulators2007
- Maximum Efficiency Point Tracking (MEPT) Method and Digital Dead Time Control ImplementationIEEE Transactions on Power Electronics, 2006
- Reverse recovery processes in silicon power rectifiersProceedings of the IEEE, 1967