Magnetic Gear: Radial Force, Cogging Torque, Skewing, and Optimization
Authors:
- 20 May 2016
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industry Applications
- Vol. 52 (5) , 3822-3830
Abstract
Magnetic gears are able to transmit torque between an input and an output shaft without mechanical contact. As for electrical drives, torque density, acoustic noise, and torque ripple are of primary concern. This paper describes the influence of the pole numbers on the radial forces and the cogging torques. We show how continuous and discrete skewing can suppress torque harmonics effectively. Further, we investigated different simulation modes for magnetic gears using finite-element software. A multiobjective optimization was conducted to find a Pareto-optimal magnetic gear, whose cogging torque was minimized by skewing one rotor. Finally, we present a prototype with a gear ratio of 1:21, and compare finite-element results with the measurements of unskewed and skewed magnetic gears.Keywords
Funding Information
- Austrian COMET-K2
- Austrian federal government
- federal state of Upper Austria
This publication has 11 references indexed in Scilit:
- Magnetic gear: Radial force, cogging torque, skewing and optimization2015
- Construction of a low speed flux focusing magnetic gear2013
- A Flux Focusing Axial Magnetic GearIEEE Transactions on Magnetics, 2013
- Design and Operation of a Magnetic Continuously Variable TransmissionIEEE Transactions on Industry Applications, 2012
- Torque Analysis of a Novel Non-Contact Permanent Variable TransmissionIEEE Transactions on Magnetics, 2011
- Comparative Study Between Mechanical and Magnetic Planetary GearsIEEE Transactions on Magnetics, 2010
- A Coaxial Magnetic Gear With Halbach Permanent-Magnet ArraysIEEE Transactions on Energy Conversion, 2010
- Design, analysis and realisation of a high-performance magnetic gearIEE Proceedings - Electric Power Applications, 2004
- Influence of design parameters on cogging torque in permanent magnet machinesIEEE Transactions on Energy Conversion, 2000
- Effect of skew, pole count and slotcounton brushless motor radial force, cogging torque and back EMFIEE Proceedings - Electric Power Applications, 1997