Influence of mixing procedures and mica addition on properties of NR/BR vulcanizates. I
- 20 September 2004
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 94 (4) , 1575-1585
Abstract
Elastomeric compositions of natural rubber (NR) and polybutadiene rubber (BR) in a 1 : 1 ratio (w/w), with mica in the range 0–30 phr, were investigated. For all compositions the same formulation was used but two different additives incorporation sequences were followed. The results of the tests showed that the mechanical performance is sequence‐dependent, as the two elastomers have very different rheometric characteristics. It was also observed that mica, when present in amounts of 20 and 30 phr, improves the mechanical properties. Scanning electron microscopy (SEM) permitted the observation of the fracture behavior of each composition, and dynamic mechanical thermal analysis (DMTA) suggested different migration tendencies of the additives in each phase, thus corroborating the differences found for the mechanical properties. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 94: 1575–1585, 2004Keywords
This publication has 10 references indexed in Scilit:
- Vulcanization of cis- and trans-polyisoprene and their blends: crystallization characteristics and propertiesEuropean Polymer Journal, 2001
- Vulcanization of cis- and trans-polyisoprene and their blends: cure characteristics and crosslink distributionEuropean Polymer Journal, 2001
- Kinetics of sulfur vulcanization of NR, BR, SBR, and their blends using a rheometer and DSCJournal of Applied Polymer Science, 1996
- Effects of silane coupling agents on mica‐filled styrene‐butadiene rubberJournal of Applied Polymer Science, 1989
- Scanning Electron Microscopy Examination of the Fracture Surface of NR/SBR and NR/BR BlendsInternational Journal of Polymeric Materials and Polymeric Biomaterials, 1988
- Studies on the cure characteristics and vulcanizate properties of 50/50 NR/SBR blendJournal of Applied Polymer Science, 1988
- Studies on the Cure Characteristics and Vulcanizate Properties of 50/50 NR/BR BlendInternational Journal of Polymeric Materials and Polymeric Biomaterials, 1987
- Use of dynamic mechanical analysis in comparing vulcanization of different phases in NR/BR and IR/BR blendsJournal of Polymer Science Part C: Polymer Letters, 1984
- Flow of carbon black loaded styrene‐butadiene (SBR)‐cis‐polybutadiene blends through capillary dies—influence of mixing and the location of carbon blackPolymer Engineering & Science, 1981
- Polymer/Solvent Interaction ParametersRubber Chemistry and Technology, 1966