Effect of Process Parameters on Foam Bitumen-based Road Material Production at Ambient Temperature
Authors:
- Bogdan CazacliuBCBogdan Cazacliu
- Marian PeticilaMPMarian Peticila
- Bernard GuieysseBGBernard Guieysse
- Jacques ColangeJCJacques Colange
- Cédric LerouxCLCédric Leroux
- Jacques BonvalletJBJacques Bonvallet
- Richard BlaszczykRBRichard Blaszczyk
- 1 January 2008
- journal article
- Published by Taylor & Francis in Road Materials and Pavement Design
- Vol. 9 (3) , 499-523
Abstract
The production by batch cold-mix technique of foam bitumen-based bound graded aggregates is studied at laboratory scale. The influence of some mixing parameters (mixing system, mixing time, shaft speed, aggregates temperature and foam characteristics) and bitumen content is analyzed. An original developed test permits a measure of the mixture microstructure. A twin-shaft mixer gives better results than a planetary mixer. The mixture temperature during mixing, resulting from aggregates and foam temperatures, seems being the most influent mixing parameter. It favours the dispersion of bitumen in smaller particles of mastic. It is shown that cohesion of compacted material, measured by direct compression test, is highly dependent on the grading of mastic particle before compactionKeywords
This publication has 3 references indexed in Scilit:
- Development of (half-) warm foamed bitumen mixes: state of the artInternational Journal of Pavement Engineering, 2007
- Laboratory Investigations of Mechanical Performance of Foamed Bitumen Mixes that Use Half-Warm AggregatesTransportation Research Record: Journal of the Transportation Research Board, 2007
- Foamed Bitumens: Foamability and Foam StabilityRoad Materials and Pavement Design, 2004