Effect of Ag Particles on Wettability and Creep Rupture Life of SnCu Based Composite Solders
Authors:
- 1 May 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 650, 78-84
Abstract
Particle-enhanced is the way to improve properties of solder alloys. In the present work, the influence of Ag particle-enhanced on the wettability and creep rupture life of 99.3Sn0.7Cu eutectic solder with Ag content of 1vol% to 10vol% were investigated. It was indicated that the wettability of the composite solders could be improved by adding minute amount of Ag particles. With increasing the amount of Ag particles, the spreading areas of the composite solders increased when Ag was below 5vol%. When Ag was above 5vol%, the spreading areas started decreasing. When Ag content was up to 10vol%, the wettability of the composite solder sharply deteriorated. In addition, the creep rupture lives of the composite solders were longer than that of 99.3Sn0.7Cu eutectic solder at the same condition. When Ag content was 5vol%, the creep rupture life of the composite solder was the longest among the investigated composite solders and about 23 times of that of 99.3Sn0.7Cu eutectic solder.Keywords
This publication has 11 references indexed in Scilit:
- Constitutive Relations for Creep in a SnCu-Based Composite Solder Reinforced with Ag ParticlesJournal of Electronic Materials, 2009
- Processing and aging characteristics of eutectic Sn-3.5Ag solder reinforced with mechanically incorporated Ni particlesJournal of Electronic Materials, 2001
- Creep properties of Sn-Ag solder joints containing intermetallic particlesJOM, 2001
- The effect of small additions of copper on the aging kinetics of the intermetallic layer and intermetallic particles of eutectic tin-silver solder jointsJournal of Electronic Materials, 2000
- Formation and growth of interfacial intermetallic layers in eutectic Sn-Ag solder and its composite solder jointsJournal of Materials Science: Materials in Electronics, 2000
- Quantification of creep strain distribution in small crept lead-free in-situ composite and non composite solder jointsMaterials Science and Engineering: A, 2000
- Effect of cooling rate on microstructure and mechanical properties of eutectic Sn-Ag solder joints with and without intentionally incorporated Cu6Sn5 reinforcementsJournal of Electronic Materials, 1999
- Significantly enhanced creep resistance in low-melting-point solders through nanoscale oxide dispersionsApplied Physics Letters, 1998
- Crack Propagation in Solder Joints During Thermal-Mechanical CyclingJournal of Electronic Packaging, 1994
- Superplastic Creep of Eutectic Tin-Lead Solder JointsJournal of Electronic Packaging, 1991