Performance of Three-Dimensional Slope Stability Methods in Practice
Authors:
- 1 November 1998
- journal article
- research article
- Published by American Society of Civil Engineers (ASCE) in Journal of Geotechnical and Geoenvironmental Engineering
- Vol. 124 (11) , 1049-1060
Abstract
Study of several field case histories has shown that the difference between two- and three-dimensional factors of safety is most pronounced in cases that involve a translational failure. Two- and three-dimensional slope stability analyses of field case histories and a parametric study of a typical slope geometry revealed that commercially available three-dimensional slope stability programs have a number of limitations with respect to (1) accounting for the shear resistance along the sides of the sliding mass; (2) modeling the stress-dependent nature of failure envelopes of the materials involved; and (3) considering the internal forces in the slide mass. These limitations can significantly affect the calculated factor of safety for a translational failure mode. A technique is presented to overcome some of these limitations and provide a better estimation of the three-dimensional factor of safety. Field case histories are presented to show the importance of using a three-dimensional analysis in back-calculating the mobilized shear strength of the materials involved in a slope failure and in the design of slopes with complicated topography, shear strength conditions, and/or pore-water pressures.Keywords
This publication has 24 references indexed in Scilit:
- Evaluation of a three-dimensional method of slope stability analysisCanadian Geotechnical Journal, 1989
- Three-dimensional analysis of slides in cohesive soilsGéotechnique, 1988
- On the ratio of factors of safety in slope stability analysesGéotechnique, 1987
- An extension of Bishop's simplified method of slope stability analysis to three dimensionsGéotechnique, 1987
- Three-dimensional limit equilibrium analysis of slopesGéotechnique, 1983
- Three-Dimensional Slope Stability Analysis1981
- Comparison of slope stability methods of analysisCanadian Geotechnical Journal, 1977
- End Effects on Stability of Cohesive SlopesJournal of the Geotechnical Engineering Division, 1975
- Waco Dam SlideJournal of the Soil Mechanics and Foundations Division, 1967
- The use of the Slip Circle in the Stability Analysis of SlopesGéotechnique, 1955