Integrated real-time control strategy in multi-tank A 2 O process for biological nutrient removal treating real domestic wastewater
Open Access
- 1 February 2017
- journal article
- Published by Scientific Scholar in Arabian Journal of Chemistry
- Vol. 10, S1041-S1054
Abstract
An integrated real-time anaerobic–anoxic/oxic (A2O) operated with multi-tank called IMT–A2O process was designed and operated with fluctuating influent loads for biological nutrient removal for treating real domestic wastewater. IMT–A2O process, a “phased isolation tank” technology, varies both aeration pattern and flow path in a continuous flow multi-tank system to force fluctuation of organic and nutrient concentrations in process reactors. Using an eight-phase cycle, desired biochemical transformations, are accomplished at different times in the same tank. On-line sensors (pH, ORP, and DO) were used as real-time control parameters to adjust the duration of each operational phase in the IMT–A2O process. The control system is an algorithm that automatically adjusts the cycle length to the influent wastewater characteristics according to the end points. It was found that on-line sensor values of pH, ORP, and DO were somehow related with the dynamic behaviors of nutrient concentrations in IMT–A2O. The algorithm acts in the reaction phases of the IMT–A2O cycle using ORP and pH break points of tank one to distinguish the end of denitrification and the beginning of phosphorus release, pH break point of tank two to control the end of denitrification and beginning of phosphorus release and a sudden increase in DO pattern, pH break point and ORP to control phosphorus uptake and the end of the nitrification process. Although the fluctuations in raw wastewater concentration are extreme; an influent with a low C/N ratio is deficient in organic carbon, and a low carbon source level can limit the overall biological denitrification process, the average removal efficiencies achieved for COD, ammonia–nitrogen, total nitrogen and total phosphorus were not less than 76.11%, 87.78%, 76.45% and 83.75%, respectively, using the integrated real-time control strategy. The integrated IMT–A2O exhibited a better performance in nutrient removal than the fixed-time IMT–A2O processKeywords
This publication has 21 references indexed in Scilit:
- Shortcut nitrification–denitrification by real-time control strategiesBioresource Technology, 2009
- Shortcut biological nitrogen removal in hybrid biofilm/suspended growth reactorsProcess Biochemistry, 2007
- Set up and assessment of a control strategy in a SBR in order to enhance nitrogen and phosphorus removalProcess Biochemistry, 2006
- Fuzzy control of dissolved oxygen in a sequencing batch reactor pilot plantChemical Engineering Journal, 2005
- Integrated real-time control strategy for nitrogen removal in swine wastewater treatment using sequencing batch reactorsWater Research, 2004
- Nitrification with high nitrite accumulation for the treatment of wastewater with high ammonia concentrationWater Research, 2003
- Effectiveness of oxidation-reduction potential and pH as monitoring and control parameters for nitrogen removal in swine wastewater treatment by sequencing batch reactorsJournal of Bioscience and Bioengineering, 2003
- The sharon process: An innovative method for nitrogen removal from ammonium-rich waste waterWater Science & Technology, 1998
- Real-time control of nitrogen removal using three ORP bending points: Signification, control strategy and resultsWater Science & Technology, 1996
- A rapid physical-chemical method for the determination of readily biodegradable soluble COD in municipal wastewaterWater Research, 1993