Effects of processing parameters on residual stress fields of 2024-T351 alloy blade subjected to massive double-sided laser peening treatment
- 1 May 2022
- journal article
- research article
- Published by Laser Institute of America in Journal of Laser Applications
- Vol. 34 (2) , 022015
Abstract
Double-sided laser shot peening (DSLSP) is a promising technique for improving mechanical properties for thin-section components. Residual stress (RS) field induced in the thin 2024-T351 alloy blade by DSLSP was investigated through experiments and finite element simulation. The effects of key parameters, such as pulse scanning patterns, overlapping rates, and DSLSP modes, on the RS field were analyzed. The model was validated by comparing the simulation results with experiment data. The results revealed that the scanning patterns advertently influenced the RS distribution, and compressive residual stresses were found to exist inside the curved thin-section blade. The overlapping rate of 70% could drive the tensile stress (TS) distributed at the near-surface into a fully compressed state, while it could also cause a large-scale TS concentration at the edge of the blade. Moreover, the mechanism of shock wave reflection-coupling on RS distribution with two DSLSP modes was also clearly revealed. The alternate double-sided laser peening mode would greatly limit the edge stress concentration and result in a better RS distribution.Keywords
Funding Information
- National Natural Science Foundation of China (11974122)
- The Scientific and Technological Plan of Guangdong Province China (2019B090905005)
This publication has 33 references indexed in Scilit:
- Residual stress distribution of Ti-6Al-4V alloy under different ns-LSP processing parametersApplied Surface Science, 2013
- Effects of laser shock processing with different parameters and ways on residual stresses fields of a TC4 alloy bladeMaterials Science and Engineering: A, 2013
- Investigation of Laser Shock Peening on Aero-Engine Compressor Rotor BladeKey Engineering Materials, 2008
- The Effect of Fatigue on Residual Peening Stresses in Aerospace ComponentsMaterials Science Forum, 2005
- Numerical simulation of surface deformation and residual stresses fields in laser shock processing experimentsApplied Surface Science, 2004
- Micro Scale Laser Shock Processing of Metallic ComponentsJournal of Manufacturing Science and Engineering, 2002
- Shock waves from a water-confined laser-generated plasmaJournal of Applied Physics, 1997
- Laser shock processing of aluminium alloys. Application to high cycle fatigue behaviourMaterials Science and Engineering: A, 1996
- Physical study of laser-produced plasma in confined geometryJournal of Applied Physics, 1990
- Pulsed laser induced deformation in an Fe-3 Wt Pct Si alloyMetallurgical Transactions A, 1977