Analytical study of parameters affecting entropy generation of nanofluid turbulent flow in channel and micro-channel
Open Access
- 1 January 2016
- journal article
- Published by National Library of Serbia in Thermal Science
- Vol. 20 (6) , 2037-2050
Abstract
In this study, thermo-physical and geometrical parameters affecting entropy generation of nanofluid turbulent flow such as the volume fraction, Reynolds number and diameter of the channel and micro-channel with circular cross section under constant flux are examined analytically. Water is used as a base fluid of nanofluid with nanoparticles of Ag, Cu, CuO and TiO2. The study is conducted for Reynolds numbers of 20000, 40000 and 100000, volume fractions of 0, 0.01, 0.02, 0.03 and 0.04, channel diameters of 2, 4, 6 and 8 cm and micro-channel diameters of 20, 40, 60 and 80 micrometers. Based on the results, the most of the generated entropy in channel is due to heat transfer, and also, with increasing the diameter of the channel, Bejan number increases. The contribution of entropy generation due to heat transfer in the micro-channel is very poor and the major contribution of entropy generation is due to friction. The maximum amount of entropy generation in channel belongs to nanofluids with Ag, Cu, CuO and TiO2 nanoparticles, respectively, while in the micro-channel this behavior is reversed; and the minimum entropy generation happens in nanofluids with Ag, Cu, CuO and TiO2 nanoparticles, respectively. In channel and micro-channel, for all nanofluids except for the water-TiO2, with increasing volume fraction of nanoparticles, the entropy generation decreases. In channel and micro-channel, the total entropy generation increases as Reynolds number augments.Keywords
This publication has 15 references indexed in Scilit:
- Entropy generation during fully-developed forced convection in parallel-plate micro-channels at high zeta-potentialsInternational Journal of Heat and Mass Transfer, 2014
- Entropy generation analysis of turbulent convection flow of Al2O3–water nanofluid in a circular tube subjected to constant wall heat fluxEnergy Conversion and Management, 2014
- Entropy generation analysis of nanofluid flow in a circular tube subjected to constant wall temperatureInternational Communications in Heat and Mass Transfer, 2012
- Analysis of entropy generation between co-rotating cylinders using nanofluidsEnergy, 2012
- Entropy generation of viscous dissipative nanofluid flow in microchannelsInternational Journal of Heat and Mass Transfer, 2012
- Entropy generation due to flow and heat transfer in nanofluidsInternational Journal of Heat and Mass Transfer, 2010
- Entropy Generation Analysis for Nanofluid Flow in MicrochannelsJournal of Heat Transfer, 2010
- Numerical investigation on developing laminar forced convection and entropy generation in a wavy channelInternational Communications in Heat and Mass Transfer, 2007
- Thermodynamic analysis of optimal mass flow rate for fully developed laminar forced convection in a helical coiled tube based on minimal entropy generation principleEnergy Conversion and Management, 2006
- The Viscosity of Concentrated Suspensions and SolutionsThe Journal of Chemical Physics, 1952