The Use of Cellulose Membrane to Eliminate Burst Release from Intravaginal Rings
- 20 April 2016
- journal article
- research article
- Published by Springer Nature in The AAPS Journal
- Vol. 18 (4) , 960-971
Abstract
Burst release was observed when ethylene vinyl acetate copolymer (EVA) intravaginal rings were tested for progesterone release in our previous work (Helbling et al. Pharm Res. 31(3):795-808, 2014). Burst release is undesirable in controlled delivery devices because release is uncontrollable and higher levels of active pharmaceutical ingredient could lead to the occurrence of adverse effect. The present contribution is about the use of membranes to coat EVA rings to eliminate burst release. Physicochemical state of progesterone in uncoated rings and the solubility and diffusion coefficient in membrane were studied. Hormone delivery from several rings of different sizes was compared. A mathematical model was used to analyze the effects of membrane properties on delivery rate. No chemical interactions were detected between hormone and polymer. Hormone was mainly forming amorphous aggregates inside rings, and migration to membrane was not observed during storage. Diffusion coefficient was smaller in membrane (similar to 10(-8) cm(2) s(-1)) than in matrix (similar to 10(-7) cm(2) s(-1)). Zero-order release kinetics were obtained for coated rings, and release rate decreases as the thickness of the coat increases. Cellulose membrane successfully eliminates burst release and controls the delivery from EVA rings. The equations developed can be used to determine the appropriate coat thickness to produce specific release rate.Keywords
This publication has 50 references indexed in Scilit:
- Controlled drug release via minimization of burst release in pH-response kappa-carrageenan/polyvinyl alcohol hydrogelsChemical Engineering Research and Design, 2013
- Modeling of drug release from matrix systems involving moving boundaries: Approximate analytical solutionsInternational Journal of Pharmaceutics, 2011
- Modelling drug release from inert matrix systems: From moving-boundary to continuous-field descriptionsInternational Journal of Pharmaceutics, 2011
- Quantifying sustained release kinetics from a polymer matrix including burst effectsJournal of Membrane Science, 2011
- Study of Polymorphs of Progesterone by Novel Melt Sonocrystallization Technique: A Technical NoteAAPS PharmSciTech, 2010
- Introduction and Overview of Oral Controlled Release Formulation Design2010
- Differential scanning calorimetry (DSC) and temperature-modulated DSC study of three mouthguard materialsDental Materials, 2007
- Hormonal Contraception and LactationJournal of Human Lactation, 1996
- Thermoanalysis of microspheresThermochimica Acta, 1995
- Polymorphism of progesteroneJournal of Thermal Analysis and Calorimetry, 1991