Studies on structural foam processing II. Bubble dynamics in foam injection molding
Authors:
- 1 July 1978
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 18 (9) , 699-710
Abstract
An experimental study was carried out to gain a better understanding of the dynamic behavior of gas bubbles during the structural foam injection molding operation. For the study, a rectangular mold cavity with glass windows on both sides was constructed, which permitted us to record on a movie film the dynamic behavior of gas bubbles in the mold cavity as a molten polymer containing inert gas was injected into it. The mold was designed so that either isothermal or nonisothermal injection molding could be carried out. Materials used were polystyrene, high‐density polyethylene, and polycarbonate. As chemical blowing agents, sodium bicarbonate (which generates carbon dioxide), a proprietary hydrazide and 5‐phenyl tetrazole, both generating nitrogen, were used. Injection pressure, injection melt temperature, and mold temperature were varied to investigate the kinetics of bubble growth (and collapse) during the foam injection molding operation. It was found that the processing variables (e.g., the mold temperature, the injection pressure, the concentration of blowing agent) have a profound influence on the nucleation and growth rates of gas bubbles during mold filling. Some specific observations made from the present study are as follows: an increase in melt temperature, blowing agent concentration, and mold temperature brings about an increase in bubble growth but more non‐uniform cell size and its distribution, whereas an increase in injection pressure (and hence injection speed) brings about a decrease in bubble growth but more uniform cell size and its distribution. Whereas almost all the theoretical studies published in the literature deal with the growth (or collapse) of a stationary single spherical gas bubble under isothermal conditions, in structural foam injection molding the shape of the bubble is not spherical because the fluid is in motion during mold filling. Moreover, a temperature gradient exists in the mold cavity and the cooling subsequent to mold filling influences bubble growth significantly. It is suggested that theoretical study be carried out on bubble growth in an imposed shear field under nonisothermal conditions.Keywords
This publication has 19 references indexed in Scilit:
- Studies on structural foam processing I. The rheology of foam extrusionPolymer Engineering & Science, 1978
- Development of stress birefringence and flow patterns during mold fillin and coolingPolymer Engineering & Science, 1978
- An experimental technique for predicting foam processability and physical propertiesPolymer Engineering & Science, 1976
- Jetting phenomena in injection mold filling mold fillingPolymer Engineering & Science, 1976
- Structural Foam Molding ParametersJournal of Cellular Plastics, 1976
- Bubble growth in thermoplastic structural foamsPolymer Engineering & Science, 1976
- Dynamics of Phase Growth in Viscous, Non-Newtonian Liquids. Initial Stages of GrowthIndustrial & Engineering Chemistry Fundamentals, 1971
- Flow behavior of polyethylene melts containing dissolved gasesJournal of Polymer Science Part C: Polymer Symposia, 1971
- Diffusion and solution of gases into thermally softened or molten polymers: Part II. Relation of diffusivities and solubilities with temperature pressure and structural characteristicsAIChE Journal, 1969
- Diffusion and solution of gases in thermally softened or molten polymers: Part I. Development of technique and determination of dataAIChE Journal, 1966