Effect of Short-Term Low-Temperature Austempering on the Microstructure and Abrasive Wear of Medium-Carbon Low-Alloy Steel
Authors:
Open Access
- 16 April 2021
- journal article
- research article
- Published by Springer Nature in Metals and Materials International
- Vol. 27 (9) , 3115-3131
Abstract
Nano-bainitic steels have attracted great attention for good wear resistance. In this research, a medium-carbon low-alloyed steel was austempered at a low temperature close to its martensite-start temperature for various times to obtain mixed microstructure of nano-bainite, martensite and retained austenite. The austempered samples were characterised comprehensively by field-emission SEM and quantitative XRD. Its two-body abrasive wear property was evaluated by sliding on a SiC abrasive disc. The results revealed the formation of initial nano-width carbide-free bainitic ferrite (BF) after austempering by 10 min, whereas the BF size and amount both increased with the austempering time. The austempered samples exhibited wear coefficients lower than the quenched martensitic sample by up to 50%. SEM and TEM observations showed wear mechanisms of micro-cutting and ploughing deformation, including the formation of a nano-laminate top layer and bending deformation in the subsurface multiphase microstructure. The decreased wear loss was attributed to the role of retained austenite in the increased plasticity. GraphicKeywords
This publication has 32 references indexed in Scilit:
- Subsurface characteristics of a Fe–0.4wt%C martenstic steel abraded with nanoindentation and cross-sectional TEM techniquesWear, 2013
- Effect of Bainite Morphology on Mechanical Properties of the Mixed Bainite-martensite Microstructure in D6AC SteelJournal of Materials Science & Technology, 2012
- Examination of carbon partitioning into austenite during tempering of bainiteScripta Materialia, 2010
- Microstructures and mechanical properties of 60Si2CrVA steel by isothermal transformation at low temperatureMaterials Science and Engineering: A, 2006
- Quenching and partitioning martensite—A novel steel heat treatmentMaterials Science and Engineering: A, 2006
- On the influence of retained austenite in the abrasive wear behaviour of a laser surface melted tool steelWear, 2005
- Partitioning of carbon from supersaturated plates of ferrite, with application to steel processing and fundamentals of the bainite transformationCurrent Opinion in Solid State and Materials Science, 2004
- Development of fracture toughness of ultrahigh strength, medium carbon, low alloy steels for aerospace applicationsInternational Materials Reviews, 2000
- Martensite in steel: strength and structureMaterials Science and Engineering: A, 1999
- The nature of martensitic transformationsMaterials Science and Engineering, 1979