A Contactless Low-Carbon Steel Magnetostrictive Torquemeter: Numerical Analysis and Experimental Validation
Open Access
Abstract
Torque measurement is a key task in several mechanical and structural engineering applications. Most commercial torquemeters require the shaft to be interrupted to place the sensors between the two portions of the shaft where a torque has to be measured. Contactless torquemeters based on the inverse magnetostrictive effect represent an effective alternative to conventional ones. Most known ferromagnetic materials have an inverse magnetostrictive behavior: applied stresses induce variations in their magnetic properties. This paper investigates the possibility of measuring torsional loads applied to a shaft made of ferromagnetic steel S235 through an inverse magnetostrictive torquemeter. It consists of an excitation coil that produces a time-varying electromagnetic field inside the shaft and an array of sensing coils suitably arranged around it, in which voltages are induced. First, the system is analyzed both in unloaded and loaded conditions by a Finite Element Method, investigating the influence of relative positions between the sensor and the shaft. Then, the numerical results are compared with the experimental measurements, confirming a linear characteristic of the sensor (sensitivity about 0.013 mV/Nm for the adopted experimental setup) and revealing the consistency of the model used. Since the system exploits the physical behavior of a large class of structural steel and does not require the introduction of special materials, this torquemeter may represent a reliable, economical, and easy-to-install device.Keywords
Funding Information
- Avio Aero, A GE Aerospace company (Clean Sky 2, 1033 17/06/2022, CN00000023, I53C22000720001)
- National Recovery and Resilience Plan (NRRP) (Clean Sky 2, 1033 17/06/2022, CN00000023, I53C22000720001)
- European Union Next-GenerationEU (National Recovery and Resilience Plan (NRRP) (Clean Sky 2, 1033 17/06/2022, CN00000023, I53C22000720001)
- CN4 SPOKE N 13 (Clean Sky 2, 1033 17/06/2022, CN00000023, I53C22000720001)
This publication has 31 references indexed in Scilit:
- Analysis and Modeling of a passive force sensor based on Villari effectMathematics and Computers in Simulation, 2021
- Experimental study and numerical simulation of magnetization involved in S235 sheets used in the construction of ship hullsResults in Physics, 2019
- Experimental evaluation of external and built-in stress in Galfenol rodsPhysica B: Condensed Matter, 2018
- An analytical model for the magnetostriction strain of ferromagnetic materials subjected to multiaxial stressThe European Physical Journal Applied Physics, 2018
- Magneto-mechanical modeling of electrical steel sheetsJournal of Magnetism and Magnetic Materials, 2017
- A review of magnetostrictive iron–gallium alloysSmart Materials and Structures, 2011
- A bidirectionally coupled magnetoelastic model and its validation using a Galfenol unimorph sensorSmart Materials and Structures, 2008
- Measurement of d15 in Fe100−xGax (x=12.5,15,18.4,22), Fe50Co50, and Fe81Al19 highly textured polycrystalline rodsJournal of Applied Physics, 2008
- Residual stress simulation in welded sections of P91 pipesJournal of Materials Processing Technology, 2005
- A continuum three-dimensional, fully coupled, dynamic, non-linear finite element formulation for magnetostrictive materialsSmart Materials and Structures, 2004