Hydrophilic mechanical buffer layers and stable hydrophilic finishes on polydimethylsiloxane using combined sequential vapor infiltration and atomic/molecular layer deposition
- 21 December 2011
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 30 (1) , 01A156
Abstract
Polydimethylsiloxane (PDMS) is an important polymer material widely used for microfluidic device fabrication, microcontact lithography, and surface morphology molding. However, the hydrophobic surface limits its functionality. Low temperature atomic layer deposition (ALD) has recently been used to functionalize a wide range of polymer surfaces. In previous research, the authors were able to produce a uniform hydrophilic alumina film coating on PDMS using trimethyl aluminum/water ALD. However, the surface recovered its hydrophobicity after 24–48 h in ambient air or under inert gas storage, which was ascribed to organic species outdiffusion through the ALD layer. This paper reports a stable hydrophilic ALD surface modification on the PDMS. The PDMS substrate was first sequentially exposed to trimethylaluminum and water vapor, allowing the vapors to infiltrate and react to create a mechanical and diffusion buffer layer in the PDMS surface region. This buffer layer helps to nucleate a cohesive hydrophilic ALD or molecular layer deposition (MLD) coating and also helps prevent organic outdiffusion that typically leads to PDMS hydrophobic recovery. The results provide valuable insight into reliable surface energy and mechanical modification of PDMS using vapor-phase precursor/polymer reactions. In addition, molecular layer deposition of “alucone” coatings was also investigated to modify the PDMS surface. The experiment result showed the vapor infiltration and MLD coatings produce a viable and stable hydrophilic surface on PDMS.Keywords
This publication has 28 references indexed in Scilit:
- Surface Functionalization of Silicone Rubber for Permanent Adhesion ImprovementLangmuir, 2008
- Hydrophobic recovery of UV/ozone treated poly(dimethylsiloxane): adhesion studies by contact mechanics and mechanism of surface modificationApplied Surface Science, 2005
- A Simple Approach to Micropatterning and Surface Modification of Poly(dimethylsiloxane)Langmuir, 2004
- Solvent Compatibility of Poly(dimethylsiloxane)-Based Microfluidic DevicesAnalytical Chemistry, 2003
- Surface Modification of Sylgard-184 Poly(dimethyl siloxane) Networks by Ultraviolet and Ultraviolet/Ozone TreatmentJournal of Colloid and Interface Science, 2002
- Poly(dimethylsiloxane) as a Material for Fabricating Microfluidic DevicesAccounts of Chemical Research, 2002
- Hydrophobicity recovery of polydimethylsiloxane after exposure to corona dischargesPolymer, 1998
- Patterned Delivery of Immunoglobulins to Surfaces Using Microfluidic NetworksScience, 1997
- Hydrophobic Recovery of Plasma-Treated PolydimethylsiloxaneThe Journal of Adhesion, 1995
- Polymer microstructures formed by moulding in capillariesNature, 1995