Evidence for the Microwave Effect During Hybrid Sintering
- 13 April 2006
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 89 (6) , 1977-1984
Abstract
A microwave/conventional hybrid furnace has been used to sinter three ceramics with different microwave absorption characteristics under pure conventional and a range of microwave/conventional hybrid heating regimes. The precursor powder particle size was also varied for each material. In each case it was ensured that every sample within a series had an identical thermal history in terms of its temperature/time profile. An increase in both the onset of densification and the final density achieved was observed with an increasing fraction of microwave energy used during sintering, the effect being greatest for the materials that absorbed microwaves most readily. Twenty‐three percent greater densification was observed for submicron zinc oxide powder, the material with the largest microwave absorption capability, when sintered using hybrid heating involving 1 kW of microwave power compared with pure conventional power under otherwise identical conditions. For the ceramic with the lowest microwave absorption characteristic, alumina, the increase in densification was extremely small; partially stabilized zirconia, a moderate microwave absorber, was intermediate between the two. Temperature gradients within the samples, a potential cause of the effect, were assessed using two different approaches and found to be too small to explain the results. Hence, it is believed that clear evidence has been found to support the existence of a genuine “microwave effect.”Keywords
This publication has 15 references indexed in Scilit:
- Microwave Sintering of Alumina at 2.45 GHzJournal of the American Ceramic Society, 2003
- Temperature Measurements during Microwave Processing: The Significance of Thermocouple EffectsJournal of the American Ceramic Society, 2001
- Microstructural Development during the Microwave Sintering of Yttria—Zirconia CeramicsJournal of the American Ceramic Society, 1997
- Possibility of plastic deformation of an ionic crystal due to the nonthermal influence of a high-frequency electric fieldPhysical Review B, 1994
- Microwave Radiation Effects on Ionic Current in Ionic Crystalline SolidsMRS Proceedings, 1994
- Microwave Processing of Polymers - An OverviewMRS Proceedings, 1992
- Microwave-Assisted Organic SynthesisMRS Proceedings, 1992
- Ceramic Powders Generated by Metallorganic and Microwave ProcessingMRS Proceedings, 1992
- Studies of Nonthermal Effects During Intense Microwave Heating of Crystalline SolidsMRS Proceedings, 1992
- Reaction Sintering of Ceramic Materials by Microwave HeatingMRS Proceedings, 1992