Fuzzy logic controller for a retrofitted closed-loop injection moulding machine
Authors:
- 1 February 2000
- journal article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering
- Vol. 214 (1) , 9-22
Abstract
For the purposes of producing precise products and providing the flexibility for products variation, an open-loop control commercial injection moulding machine is retrofitted into a closed-loop control system for monitoring the filling and post-filling phases of the injection processes. The hydraulic control unit, control and interface circuits, safety limit switches and personal-computer-based controller were redesigned and constructed. Since the injection moulding processes have complicated non-linear dynamics and model uncertainty, the application of a classical proportional-integral-derivative controller has adaptivity and robustness problems, especially with regards to the pressure control during compression phase. Here, an intelligent fuzzy controller is employed to adjust the injection speed of the filling phase and to control the nozzle pressure of the post-filling phase. The experimental results show that this controller has good performance in actual injection moulding processes.Keywords
This publication has 15 references indexed in Scilit:
- Dynamics and control of pressure in the injection molding of thermoplasticsPolymer Engineering & Science, 1987
- The Correlation Between the Residual Stresses of ABS Terpolymers and Injection Molding ConditionsJournal of Engineering Materials and Technology, 1987
- Pressure‐Induced densification in injection moldingPolymer Engineering & Science, 1986
- Pressure build‐up during the packing stage of injection moldingPolymer Engineering & Science, 1985
- Evaluation of simple dynamic models and controllers for hydraulic and nozzle pressure in injection moldingPolymer Engineering & Science, 1985
- A study in injection molding dynamicsPolymer Engineering & Science, 1984
- Process control of injection moldingPolymer Engineering & Science, 1983
- Residual stresses in polymers III: The influence of injection‐molding process conditionsPolymer Engineering & Science, 1982
- Analysis of the packing stage in injection moldingPolymer Engineering & Science, 1981
- The injection molding of thermoplastics part I: Theoretical modelPolymer Engineering & Science, 1972