Compressor Surge Mitigation in Turbocharged Spark-Ignition Engines without an Anti-Surge Control System during Load-Decrease Operation
Open Access
- 8 February 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (3) , 1751
Abstract
Automotive manufacturers are showing an increasing preference for hybrid powertrains based on advanced gasoline engines. The most extended solution to improve fuel economy in these engines consists in downsizing with direct injection, while turbocharging is required to compensate the consequent power loss. However, turbocharging is associated with different issues, such as compressor surge. It can appear during fast throttle closings (tip-outs), when the engine air flow is abruptly reduced. A usual strategy to manage this kind of maneuver is the installation of an anti-surge valve (ASV) that connects the compressor inlet and outlet when approaching the surge limit. In pursuit of cost reduction, the removal of the ASV system was assessed in this research. To this end, tip-outs without ASV were tested in a turbocharged gasoline engine equipped with a low-pressure EGR loop, and two strategies were analyzed: throttle closure optimization and reduction of the compressor inlet pressure through the intake flap (located upstream of the compressor to increase the EGR rate). The instantaneous compressor outlet pressure and its time derivative were used for surge detection. Experimental tip-outs without ASV revealed that applying a certain intake flap closing combined with an optimized throttle actuation led to a fast torque decrease, similar to that observed for the reference case with ASV, without compressor instabilities.Keywords
This publication has 36 references indexed in Scilit:
- Filters in Control Systems2012
- On the effect of pulsating flow on surge margin of small centrifugal compressors for automotive enginesExperimental Thermal and Fluid Science, 2009
- Variable valve timing for fuel economy improvement in a small spark-ignition engineApplied Energy, 2009
- Experiments and modelling of surge in small centrifugal compressor for automotive enginesExperimental Thermal and Fluid Science, 2008
- Potential of flow pre-whirl at the compressor inlet of automotive engine turbochargers to enlarge surge margin and overcome packaging limitationsInternational Journal of Heat and Fluid Flow, 2007
- Surge limit definition in a specific test bench for the characterization of automotive turbochargersExperimental Thermal and Fluid Science, 2006
- Surge Avoidance in Gas Compression SystemsJournal of Turbomachinery, 2004
- The Inlet Flow Structure of a Centrifugal Compressor Stage and Its Influence on the Compressor PerformanceJournal of Fluids Engineering, 2003
- High-Speed Centrifugal Compressor Surge Initiation CharacterizationJournal of Propulsion and Power, 2002
- Surge Dynamics in a Free-Spool Centrifugal Compressor SystemJournal of Turbomachinery, 1992