Development of a Three-Degree-of-Freedom Ultrasonic Vibration Tool Holder for Milling and Drilling
- 25 March 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 24 (3) , 1238-1247
Abstract
This paper presents a three-degree-of-freedom (3DOF) ultrasonic vibration tool holder for milling and drilling operations. The 3DOF vibrations are generated by a novel actuator that contains three groups of piezoelectric rings actuating in X, Y and Z directions at the natural frequencies of the structure. The vibrations in XY plane are excited at the frequency but with slightly different amplitudes to produce an elliptical locus for intermittent tool-workpiece contact, which assists milling process, and the vibrations along Z axis are used in drilling operations. The 3DOF ultrasonic vibration actuator excites the structure's natural frequencies, which are above 16 kHz with amplitudes up to 20-25 μm. A control system has been developed for tracking the resonance frequencies during cutting from the phase of actuator's impedance. Preliminary cutting tests show that the cutting forces are reduced by over 30% with the ultrasonic vibration assisted milling and drilling operations.Keywords
Funding Information
- National Sciences and Engineering Research Council of Canada CANRIMT2
- Strategic Research Network (NETGP 479639-15)
This publication has 23 references indexed in Scilit:
- A design approach for longitudinal–torsional ultrasonic transducersSensors and Actuators A: Physical, 2013
- Feasibility study of the rotary ultrasonic elliptical machining of carbon fiber reinforced plastics (CFRP)International Journal of Machine Tools and Manufacture, 2012
- A cutting force model for rotary ultrasonic machining of brittle materialsInternational Journal of Machine Tools and Manufacture, 2012
- An ultrasonic elliptical vibration cutting device for micro V-groove machining: Kinematical analysis and micro V-groove machining characteristicsJournal of Materials Processing Technology, 2007
- Rotary ultrasonic machining of ceramic matrix composites: feasibility study and designed experimentsInternational Journal of Machine Tools and Manufacture, 2005
- Analysis of chatter suppression in vibration cuttingInternational Journal of Machine Tools and Manufacture, 2002
- Development of Ultrasonic Elliptical Vibration Controller for Elliptical Vibration CuttingCIRP Annals, 2002
- Development of a practical ultrasonic vibration cutting tool systemJournal of Materials Processing Technology, 2001
- Ultaprecision Diamond Cutting of Hardened Steel by Applying Elliptical Vibration CuttingCIRP Annals, 1999
- Ultrasonic Elliptical Vibration CuttingCIRP Annals, 1995