Comparing fiber orientation evolution between startup of shear and nonlubricated squeeze flow
- 23 September 2020
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 42 (1) , 98-112
Abstract
Light weighting has become an integral part of vehicle design. This strategy makes use of fiber‐reinforced thermoplastics, which can be injection molded into complex shapes. Composite design work requires knowledge of the orientation state throughout a part to predict properties like stiffness and strength. Although evolution models for the orientation state have been developed, each requires empirical parameters, and no standard method for obtaining these exists. This work continues efforts to find such a test, particularly for long (average length > 1 mm) glass fiber composites. Here, a polypropylene loaded with 30, 40, and, 50 wt% long glass fiber is subjected to startup of shear and nonlubricated squeeze flow (NLSF). The orientation evolution was reported for both flows and an attempt was made at fitting several orientation models to the data. The measured orientation evolution from startup of shear was slower than expected, and this slower evolution appears to result from the combination of the initial orientation state and fiber concentration. On the other hand, the measured orientation profile from NLSF was found to be essentially independent of fiber concentration. However, the NLSF orientation profile could not be replicated with a single set of parameters. Rather, shear‐like parameters made reasonable predictions in shear‐dominated regions, and extension‐like parameters made reasonable predictions in extension‐dominated areas, in concordance with results from short glass fiber composites.Keywords
This publication has 24 references indexed in Scilit:
- Evolution of fibre orientation in radial direction in a center-gated disk: Experiments and simulationComposites Part A: Applied Science and Manufacturing, 2013
- Using startup of steady shear flow in a sliding plate rheometer to determine material parameters for the purpose of predicting long fiber orientationJournal of Rheology, 2012
- Prediction of fiber orientation in the injection molding of long fiber suspensionsPolymer Composites, 2012
- Multiscale modeling of unsaturated flow in dual-scale fiber preforms of liquid composite molding I: Isothermal flowsComposites Part A: Applied Science and Manufacturing, 2012
- An anisotropic rotary diffusion model for fiber orientation in short- and long-fiber thermoplasticsJournal of Non-Newtonian Fluid Mechanics, 2009
- Rheology of highly concentrated planar fiber suspensionsJournal of Rheology, 2005
- Stereological measurement and error estimates for three‐dimensional fiber orientationPolymer Engineering & Science, 1992
- Orientation Behavior of Fibers in Concentrated SuspensionsJournal of Reinforced Plastics and Composites, 1984
- Lagrangian-Eulerian finite element formulation for incompressible viscous flowsComputer Methods in Applied Mechanics and Engineering, 1981
- The motion of ellipsoidal particles immersed in a viscous fluidProceedings of the Royal Society of London. Series A, Containing Papers of a Mathematical and Physical Character, 1922