Fabricating patch antennas within complex dielectric structures through multi-process 3D printing
Authors:
- Eric MacDonaldEMEric MacDonald
- David EspalinDEDavid Espalin
- Derek DoyleDDDerek Doyle
- Jazmin MuñozJMJazmin Muñoz
- Steven AmbrizSASteven Ambriz
- Jose CoronelJCJose Coronel
- Andrew WilliamsAWAndrew Williams
- Ryan WickerRWRyan Wicker
- 1 August 2018
- journal article
- research article
- Published by Elsevier in Journal of Manufacturing Processes
- Vol. 34, 197-203
Abstract
No abstract availableKeywords
Funding Information
- Air Force Research Laboratory (FA8650-12-2-7230)
- University of Texas at El Paso
This publication has 22 references indexed in Scilit:
- 3D Printing for the Rapid Prototyping of Structural ElectronicsIEEE Access, 2014
- 3D Printing multifunctionality: structures with electronicsThe International Journal of Advanced Manufacturing Technology, 2014
- 3D printing: the dawn of a new era in manufacturing?Assembly Automation, 2013
- Multi-material, multi-technology stereolithographyVirtual and Physical Prototyping, 2012
- Integrating stereolithography and direct print technologies for 3D structural electronics fabricationRapid Prototyping Journal, 2012
- Conformal Printing of Electrically Small Antennas on Three‐Dimensional SurfacesAdvanced Materials, 2011
- Direct ink-jet printing and low temperature conversion of conductive silver patternsJournal of Materials Science, 2006
- Photopolymerization monitoring of ceramic stereolithography resins by FTIR methodsJournal of Materials Science, 2005
- A dual-band circularly polarized aperture-coupled stacked microstrip antenna for global positioning satelliteIEEE Transactions on Antennas and Propagation, 1997
- An Empirical Study of Manufacturing Flexibility in Printed Circuit Board AssemblyOperations Research, 1996