Results from a U.K. Interlaboratory Project on Dry Sliding Wear of Alumina
Author:
- 1 January 1992
- book chapter
- Published by ASTM International
- p. 129-150
Abstract
Eleven U.K. laboratories performed dry pin-on-disk wear tests on a 95% alumina ceramic under a load of 40 N and at a sliding speed of 0.1 ms-1. Specimens were supplied with polished and ground finishes; the ground finish gave higher wear and lower friction than the polished specimens. Subsidiary experiments showed a large effect of humidity on wear with high wear rates at low humidity levels. The measure of wear with the best repeatability was scar size measurements at 5%, and the worst was mass loss measurements at 42% (expressed as ratios of 95% confidence intervals to the mean values). The reproducibility of friction measurements was 14%.Keywords
This publication has 8 references indexed in Scilit:
- Effect of Test Machine Dynamics on the Sliding Wear of Alumina1992
- Effects of surrounding atmosphere on the wear of sintered aluminaWear, 1991
- The affect of surface finish on the sliding wear of aluminaJournal of Materials Science, 1990
- International multilaboratory sliding wear tests with ceramics and steelWear, 1989
- Effects of test variables in wear testing of ceramicsMaterials Science and Technology, 1988
- Effects from vibrations in wear testing of ceramicsMaterials Science and Technology, 1988
- Results from a U.K. interlaboratory project on dry sliding wearWear, 1987
- Multilaboratory tribotesting: Results from the Versailles Advanced Materials and Standards programme on wear test methodsWear, 1987