Reducing torque ripple of switched reluctance machines by relocation of rotor moulding clinches
Authors:
- 8 November 2012
- journal article
- Published by Institution of Engineering and Technology (IET) in IET Electric Power Applications
- Vol. 6 (9) , 753-760
Abstract
Switched reluctance machines (SRMs) are of great interest because of their simplicity, low-cost, reliability, robustness, fault-tolerance and extended-speed constant-power operation. However, conventional SRMs suffer from high torque ripples. There exist several methods, which have been proposed to reduce torque ripples. One of the proposed methods is to change the geometric structure of the machine. However, analysis of the state-of-the-art designs show that, despite achieving favourable results in applications, the moulding pins of the machines are normally neglected. A motor that gives positive results may get affected negatively by its random moulding during its manufacturing. In this paper, mitigation of torque ripples in short-pitched SRMs (SPSRMs) and fully-pitched SRMs (FPSRMs) are investigated. Three-phase SPSRM and FPSRM are chosen for this study and the effects of the geometric points of moulding pins in the machines are studied comparatively. Maxwell 2D program is used for the analysis and two different models are compared for both SPSRM and FPSRM. The obtained results show that the torque ripples of the two machines are lower when moulding pins are closer to the rotor position. It is reduced by 2.56% at 10 Amps in the proposed SPSRM and 12% at 6 Amps in the proposed FPSRM. It is also observed that the applied method is more effective in reducing torque ripples of FPSRMs than SPSRMs.Keywords
This publication has 7 references indexed in Scilit:
- Acoustic noise reduction of a 6/4 SRM drive based on third harmonic real power cancellation and mutual coupling flux enhancementEnergy Conversion and Management, 2010
- Novel Switched Reluctance Machine Configuration With Higher Number of Rotor Poles Than Stator Poles: Concept to ImplementationIEEE Transactions on Industrial Electronics, 2009
- Multi-layer switched reluctance motor to reduce torque rippleEnergy Conversion and Management, 2008
- Direct torque control of switched reluctance motor for minimizing torque rippleInternational Journal of Applied Electromagnetics and Mechanics, 2008
- New pole tip shapes mitigating torque ripple in short pitched and fully pitched switched reluctance motorsElectric Power Systems Research, 2005
- A Switched Reluctance Machine-Based Starter/Alternator for More Electric CarsIEEE Transactions on Energy Conversion, 2004
- Fully pitched-winding switched-reluctance and stepping-motor arrangementsIEE Proceedings B Electric Power Applications, 1993