In situ radiographic and ex situ tomographic investigation of pore collapse in laser shock-loaded polyurethane foam
- 2 February 2022
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 131 (5) , 055106
Abstract
Laser-driven shock experiments were conducted at a synchrotron facility to investigate the dynamic response of polyurethane foam. These experiments were coupled to in situ x-ray imaging to radiograph foam deformations and to determine the propagation velocity of stress waves. To increase the amplitude and the duration of the pressure load generated by the laser–matter interaction, the front surface of the target was covered with a confining layer (water and BK7 glass). Preliminary calibration tests involving time-resolved velocity measurements were performed to calculate the ablation pressure on the front surface of foam samples. The calculated pressure loads were used as input data for hydrodynamic simulations, in which the foam is modeled using a homogeneous porous macroscopic model, and model predictions were compared with experimental results. A fair consistency was found for most experiments, while for the others, an overestimation of the applied pressure is suspected, likely due to a laser breakdown within the confining medium. Finally, post-shot x-ray tomography of the recovered samples showed permanent deformation of the foam, unlike what was observed under quasi-static compression, and revealed heavy damage in the vicinity of the loaded zone.Keywords
Funding Information
- Groupe Aéro Propulseur (11-EQPX-0018)
This publication has 29 references indexed in Scilit:
- Impact response of high density flexible polyurethane foamInternational Journal of Impact Engineering, 2012
- Dynamic and Quasi-Static Propagation of Compaction Waves in a Low-Density Epoxy FoamExperimental Mechanics, 2006
- A visco-hyperelastic constitutive description of elastomeric foamInternational Journal of Impact Engineering, 2004
- High-strain-rate compressive behavior of a rigid polyurethane foam with various densitiesExperimental Mechanics, 2002
- Two-dimensional response of crushable polyurethane foam to low velocity impactInternational Journal of Impact Engineering, 2000
- High strain rate compressive behaviour of aluminium alloy foamsInternational Journal of Impact Engineering, 2000
- Shock waves from a water-confined laser-generated plasmaJournal of Applied Physics, 1997
- Modelling impact deformation of foam-plate sandwich systemsInternational Journal of Impact Engineering, 1997
- Phase objects in synchrotron radiation hard x-ray imagingJournal of Physics D: Applied Physics, 1996
- Picosecond laser-induced breakdown at 5321 and 3547 Å: Observation of frequency-dependent behaviorPhysical Review B, 1977