Hybrid Buck Converter With Constant Mode Changing Point and Smooth Mode Transition for High-Frequency Applications
- 23 January 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 67 (2) , 1466-1474
Abstract
To achieve high frequency and high efficiency over a wide load range, a monolithic voltage-mode DC-DC buck converter with advanced burst mode (ABM) and pulse width modulation (PWM) is presented in this paper. The load current is detected by estimating the currents flowing through the high side and low side switches, which maintains a near constant mode changing point. A counter-based scheme is used to achieve seamless and smooth transition between PWM and ABM. Both operating modes share the same control blocks and no additional zero current detecting circuit is needed. In addition, the output stage switch size can be adjusted to reduce switching loss and improve efficiency under ultra-light load conditions. Experimental results show that the integrated 3 MHz converter achieves high efficiency from 80 to 91 %, over a wide load range, from 0.001 to 5 A. When the switch size is set to 1/3 of the maximum value, an additional 5 % efficiency improvement at under 0.1 A load can be realized. The mode changing point is set at 0.4 A with less than 10 % variation when the input voltage changes from 3 to 5 V. The load transient response is also improved significantly.Keywords
Funding Information
- National Natural Science Foundation of China (61771363)
- China Scholarship Council (201806965020)
- Open Project of CDEMC (2017KFKT/B08)
This publication has 18 references indexed in Scilit:
- Optimal peak‐efficiency control of the CMOS interleaved multi‐phase step‐down DC‐DC Converter with segmented power stageIET Power Electronics, 2016
- High‐efficiency low‐noise pulse‐width modulation DC–DC buck converter based on multi‐partition switching for mobile system‐on‐a‐chip applicationsIET Power Electronics, 2016
- Optimal Inductor Current in Boost DC/DC Converters Operating in Burst Mode Under Light-Load ConditionsIEEE Transactions on Power Electronics, 2015
- Load current‐sensing circuit integrated in high‐frequency PWM/PFM hybrid DC–DC buck converterElectronics Letters, 2014
- Mode-Selectable High-Efficiency Low-Quiescent-Current Synchronous Buck DC–DC ConverterIEEE Transactions on Industrial Electronics, 2013
- A fast and high efficiency buck converter with Switch-On-Demand Modulator for wide load range applicationsIEICE Electronics Express, 2011
- Analysis and Design of Voltage Regulator With Adaptive FET Modulation Scheme and Improved EfficiencyIEEE Transactions on Power Electronics, 2008
- A High Efficiency Dual-Mode Buck Converter IC For Portable ApplicationsIEEE Transactions on Power Electronics, 2008
- Dithering Skip Modulation, Width and Dead Time Controllers in Highly Efficient DC-DC Converters for System-On-Chip ApplicationsIEEE Journal of Solid-State Circuits, 2007
- Optimum power-saving method for power MOSFET width of DC–DC convertersIET Circuits, Devices & Systems, 2007