Relationship of Stiffness-Based Indentation Properties Using Continuous-Stiffness-Measurement Method
Open Access
Abstract
The determination of elastic modulus (E) and hardness (H) relies on the accuracy of the contact area under the indenter tip, but this parameter cannot be explicitly measured during the nanoindentation process. This work presents a new approach that can derive the elastic modulus (E) and contact depth (hc) based on measured experiment stiffness using the continuous-stiffness-measurement (CSM) method. To achieve this, an inverse algorithm is proposed by incorporating a set of stiffness-based relationship functions that are derived from combining the dimensional analysis approach and computational simulation. This proposed solution considers both the sink-in and pile-up contact profiles; therefore, it provides a more accurate solution when compared to a conventional method that only considers the sink-in contact profile. While the proposed solution is sensitive to Poisson’s ratio (ν) and the equivalent indentation conical angle (θ), it is not affected by material plasticity, including yield strength (σy) and work hardening (n) for the investigated range of 0.001 < σy/E < 0.5. The proposed stiffness-based approach can be used to consistently derive elastic modulus and hardness by using stiffness and the load-and-unload curve measured by the continuous-stiffness-measurement (CSM) method.Keywords
This publication has 29 references indexed in Scilit:
- Plasticity characteristic obtained by indentationJournal of Physics D: Applied Physics, 2008
- Pile-up/sink-in of rate-sensitive nanoindentation creeping solidsModelling and Simulation in Materials Science and Engineering, 2007
- Semi-ellipse method for accounting for the pile-up contact area during nanoindentation with the Berkovich indenterScripta Materialia, 2006
- Limit analysis-based approach to determine the material plastic properties with conical indentationJournal of Materials Research, 2006
- Scaling, dimensional analysis, and indentation measurementsMaterials Science and Engineering: R: Reports, 2004
- Measurement of hardness and elastic modulus by instrumented indentation: Advances in understanding and refinements to methodologyJournal of Materials Research, 2004
- Identification of plastic hardening parameters of metals from spherical indentation testsMaterials Science and Engineering: A, 2001
- Effects of 'sinking in' and 'piling up' on estimating the contact area under load in indentationPhilosophical Magazine Letters, 1998
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- The relation between load and penetration in the axisymmetric boussinesq problem for a punch of arbitrary profileInternational Journal of Engineering Science, 1965