Integrated Optimization Design for a Radial Turbine Wheel of a 100 kW-Class Microturbine
Authors:
- Lei FuLFLei Fu
- Zhenping FengZFZhenping Feng
- 7 November 2011
- journal article
- research article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 134 (1) , 012301
Abstract
The aerodynamic performance, structural strength, and wheel weight are three important factors in the design process of the radial turbine. This paper presents an investigation on these aspects and develops an optimization design approach for radial turbine with consideration of the three factors. The aerodynamic design for the turbine wheel with an inlet diameter of 230 mm for the 100 kW-class microturbine unit is carried out first as the original design. Then, the cylinder parabolic geometrical design method is applied to the wheel modeling and structural design, but the maximum stress predicted by finite element analysis greatly exceeds the yield limit of material. Further, the wheel weight is above 7.2 kg, thus, bringing some critical difficulties for bearing design and turbine operation. Therefore, an integrated optimization design method for radial turbine is studied and developed in this paper with focus on the wheel design. Meridional profiles and shape lines of the turbine wheel are optimized with consideration of the whole wheel weight. Main structural modeling parameters are reselected to reduce the wheel weight. Trade-off between aerodynamic performance and strength performance is highly emphasized during the optimization design. The results show that the optimized turbine wheel gets high aerodynamic performance and acceptable stress distribution with a weight less than 3.8 kg.Keywords
This publication has 9 references indexed in Scilit:
- Experimental and Numerical Investigation on Overall Performance of a Radial Inflow Turbine for 100kW Mircoturbine2007
- Tip Leakage Flow in Radial Inflow Rotor of a Microturbine With Varying Blade-Shroud Clearance2007
- Strength Design and Numerical Analysis of Radial Inflow Turbine Impeller for a 100kW Microturbine2005
- Prototype Development of a Novel Radial Flow Gas Turbine2005
- Aerothermodynamic Design and Numerical Simulation of Radial Inflow Turbine Impeller for a 100kW Microturbine2005
- Optimization of Microturbine Aerodynamics Using CFD, Inverse Design and FEM Structural Analysis: 2nd Report — Turbine Design2004
- A Unified Approach for Designing a Radial Flow Gas Turbine2002
- 25-5 Kwe Microturbine Design Aspects2000
- Theory of Blade Design for Large Deflections: Part II—Annular CascadesJournal of Engineering for Gas Turbines and Power, 1984