The Influence of Osteon Orientation on Surface Topography Parameters after Machining of Cortical Bone Tissue
Open Access
Abstract
Mechanical processing of cortical bone tissue is one of the most common surgical procedures. A critical issue accompanying this processing is the condition of the surface layer, which can stimulate tissue growth and serve as a drug carrier. A comparison of the surface condition before and after orthogonal and abrasive processing was conducted to validate the influence of bone tissue’s processing mechanism and orthotropic properties on the surface topography. A cutting tool with a defined geometry and a custom-made abrasive tool was used. The bone samples were cut in three directions, depending on the orientation of the osteons. The cutting forces, acoustic emission, and surface topography were measured. The level of isotropy and the topography of the grooves showed statistical differences relative to the anisotropy directions. After orthogonal processing, the surface topography parameter Ra was determined from 1.38 ± 0.17 μm to 2.82 ± 0.32. In the case of abrasive processing, no correlation was found between the orientation of osteons and topographical properties. The average groove density for abrasive machining was below 1004 ± 0.7, and for orthogonal, it was above 1156 ± 58. Due to the positive properties of the developed bone surface, it is advisable to cut in the transverse direction and parallel to the axis of the osteons.Keywords
Funding Information
- Politechnika Poznańska (SBAD/1565)
This publication has 49 references indexed in Scilit:
- Analysis of the Effect of Osteon Diameter on the Potential Relationship of Osteocyte Lacuna Density and Osteon Wall ThicknessThe Anatomical Record, 2011
- Age- and gender-related differences in the geometric properties and biomechanical significance of intracortical porosity in the distal radius and tibiaJournal of Bone and Mineral Research, 2010
- Lipids and Collagen Matrix Restrict the Hydraulic Permeability Within the Porous Compartment of Adult Cortical BoneAnnals of Biomedical Engineering, 2009
- Measurements of Surface Roughness in Conventional and Ultrasonically Assisted Bone DrillingAmerican Journal of Biomedical Sciences, 2009
- The role of cortical bone and its microstructure in bone strengthAge and Ageing, 2006
- Osteonal effects on elastic modulus and fatigue life in equine boneJournal of Biomechanics, 2006
- Incompatible mechanical properties in compact boneJournal of Theoretical Biology, 2004
- Prediction of fracture load at different skeletal sites by geometric properties of the cortical shellJournal of Bone and Mineral Research, 1996
- Cortical and trabecular bone contribute strength to the osteopenic distal radiusJournal of Orthopaedic Research, 1994
- Non-interacting modes for stress, strain and energy in anisotropic hard tissueJournal of Biomechanics, 1991