RESIDENCE TIME DISTRIBUTIONS IN BALL MILLS
Authors:
- 1 April 1984
- journal article
- research article
- Published by Taylor & Francis in Particulate Science and Technology
- Vol. 2 (2) , 191-209
Abstract
A review is made of the methods and theory of measurements of residence time distributions (RTD's) in mills. Literature data on RTD's is assembled. The mean residence times indicate that some industrial mills are operated in the over–filled condition, leading to poor breakage conditions. Although all RTD's are somewhat similar on a dimensionless basis, there appears to be no consistent pattern to explain differences from one mill to another. The general form of measured RTD's Ms consistent with an axial convective–raixing model, but this model does not explain why the Peclet number is independent of mill length–to–diameter ratio and mass throughput. It is concluded that substantial work remains to be done before an adequate understanding of ball mill RTD's is obtained.Keywords
This publication has 17 references indexed in Scilit:
- A comparison of the Bond method for sizing wet tumbling ball mills with a size—mass balance simulation modelPowder Technology, 1983
- Further studies of ball and powder filling effects in ball millingPowder Technology, 1982
- The estimation of rate and breakage distribution parameters from batch grinding data for a complex pyritic ore using a back-calculation methodPowder Technology, 1981
- The variation of breakage parameters with ball and powder loading in dry ball millingPowder Technology, 1980
- The back-calculation of specific rates of breakage and non-normalized breakage distribution parameters from batch grinding dataInternational Journal of Mineral Processing, 1977
- Experimental methods for grinding studies in laboratory millsPowder Technology, 1972
- The estimation of non-normalized breakage distribution parameters from batch grinding testsPowder Technology, 1972
- Methods for determination of breakage distribution parametersPowder Technology, 1972
- Introduction to the mathematical description of grinding as a rate processPowder Technology, 1971
- A solution to the batch grinding equationChemical Engineering Science, 1965