Effect of Sintering Time on the Purity and Morphology of LiTaO3
Authors:
- 1 April 2012
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 501, 129-132
Abstract
Preparation of LiTaO3 was done using the sol-gel method which is also known as the wet chemical technique. Thermal analysis (TG-DSC) of LiTaO3 precursor was studied to determine an optimized heating temperature. LiTaO3 was heated at 550 °C with different sintering time of 12, 24, 48 and 72 h. The formation of pure LiTaO3 occurred during sintering time of 72 h which was confirmed using X-ray diffraction (XRD). The morphology of pure LiTaO3 was recorded using a Scanning Electron Microscope (SEM). Pure LiTaO3 can only be formed at a longer heating time in order to complete the oxidation process.Keywords
This publication has 5 references indexed in Scilit:
- Synthesis and characterization of nanosized lithium manganate and its derivativesJournal of Power Sources, 2007
- Characterization of LiTaO3 thin films fabricated by sol–gel techniqueMicroelectronics Journal, 2007
- Stoichiometric LiTaO3 single crystal growth by double crucible Czochralski method using automatic powder supply systemJournal of Crystal Growth, 1999
- Synthesis and electrochemical studies of spinel Li1.03Mn2O4 cathode materials prepared by a sol-gel method for lithium secondary batteriesSolid State Ionics, 1997
- Saw IF Filter on LITaO3 for Color TV ReceiversIEEE Transactions on Consumer Electronics, 1978