Development of Signal Processing Circuit of a Magnetic Camera for the NDT of a Paramagnetic Material
Authors:
- 10 September 2007
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 353-358, 2379-2382
Abstract
The yoke type magnetization coil and cross type magnetizer as a magnetic source, which induce a static magnetic field on a specimen, have been used to detect cracks on a ferromagnetic material. However, the cracks on paramagnetic materials such as aluminum alloy and stainless steel cannot be detected by using a static magnetic source. This paper proposes a magnetic source, which uses the induced sheet type current, for the detection of cracks on a paramagnetic material. The sheet type AC current can be induced by using a primary coil and core. And the copper film, which includes a sheet type current, is positioned on the specimen. Eddy currents are induced around a crack on the specimen because the secondary sheet type current can be induced on the specimen surface. The signal processing electrical circuits, which measure a Hall sensor peak output with the eddy current frequency, are developed and discussed. Also the validity of the proposed signal processing circuit is verified by detection of slit type cracks and a fatigue crack, which are introduced on aluminum alloy.Keywords
This publication has 4 references indexed in Scilit:
- A Study of the Quantitative Nondestructive Evaluation Using the Cross Type Magnetic Source and the Magnetic CameraKey Engineering Materials, 2006
- Numerical Analysis of Magneto-Optical Eddy Current Imaging Using FEMKey Engineering Materials, 2006
- Modeling of Characteristics of Magneto-Optical Sensor Using FEM and Dipole Model for Nondestructive EvaluationKey Engineering Materials, 2005
- An algorithm for the characterization of surface crack by use of dipole model and magneto-optical non-destructive inspection systemKSME International Journal, 2000