DC-Contact RF MEMS Switches using Thin-Film Cantilevers
Authors:
- 1 October 2008
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 382-385
Abstract
This paper describes the development of DC-contact RF-MEMS SPST, SP3T, and SP4T switches implemented with a thin-film cantilever. Using aluminium as the sacrificial layer in the fabrication process, flat cantilevers are realized with a measured actuation voltage of 50~70 V. The SPST switch is used as a building block to realize more complicated SP3T and SP4T switches for use in true-time delay phase shifters. The preliminary measurements of the SP3T and SP4T switches demonstrate isolation of 20 dB and insertion loss less than 2 dB up to 50 GHz.Keywords
This publication has 6 references indexed in Scilit:
- Realization of low-stress Au cantilever beamsJournal of Micromechanics and Microengineering, 2007
- Mechanical properties of sacrificial polymers used in RF-MEMS applicationsJournal of Micromechanics and Microengineering, 2006
- Low-loss 2- and 4-bit TTD MEMS phase shifters based on SP4T switchesIEEE Transactions on Microwave Theory and Techniques, 2003
- A DC-to-40 GHz four-bit RF MEMS true-time delay networkIEEE Microwave and Wireless Components Letters, 2001
- MEM relay for reconfigurable RF circuitsIEEE Microwave and Wireless Components Letters, 2001
- Microswitches and microrelays with a view toward microwave applicationsInternational Journal of RF and Microwave Computer-Aided Engineering, 1999