Integrated optimization of process parameters and gate design in plastic injection moulding of A-pillar parts using simulation and neural network approaches
- 29 January 2026
- journal article
- Published by SAGE Publications in Progress in Rubber, Plastics and Recycling Technology
- Vol. 42 (4) , 418-436
Abstract
This study presents an integrated approach to minimize warpage and shrinkage in automotive A-pillar plastic components fabricated via injection moulding. The research systematically investigates the effect of key process parameters mould temperature, injection pressure, and melt temperature alongside three distinct gate configurations: single middle, double middle, and two-end double gates. Simulations were conducted using Autodesk Moldflow Adviser, and the Taguchi method was employed to design experiments and analyse the significance of each factor using signal-to-noise (S/N) ratios and ANOVA. Results indicate that melt temperature is the most influential parameter, contributing up to 96.25% to warpage formation, followed by mould temperature and injection pressure. Among the gate designs, the double middle gate configuration demonstrated the best balance between reduced deflection and structural integrity. Optimized parameters (melt temperature: 190°C, mould temperature: 20–40°C, injection pressure: 90–130 MPa) effectively reduced deflection by up to 4.50%. Furthermore, an Artificial Neural Network (ANN) model trained with experimental data accurately predicted deflection values with less than 15% deviation from simulated and actual results. The integration of simulation, statistical optimization, and machine learning provides a robust framework for enhancing dimensional accuracy and process efficiency. This study offers a scalable methodology for automotive part manufacturers seeking to optimize injection moulding processes and ensure higher product quality with reduced material waste.Keywords
This publication has 17 references indexed in Scilit:
- A predictive modelling strategy for warpage and shrinkage defects in plastic injection molding using fuzzy logic and pattern search optimizationJournal of Intelligent Manufacturing, 2024
- Analysis of Variance (ANOVA) and Design of Experiments2022
- Recent progress in minimizing the warpage and shrinkage deformations by the optimization of process parameters in plastic injection molding: a reviewThe International Journal of Advanced Manufacturing Technology, 2022
- An effect of mold surface temperature on final product properties in the injection molding of high-density polyethylene materialsPolymer Bulletin, 2020
- Modeling and Optimization of the Injection‐Molding Process: A ReviewAdvances in Polymer Technology, 2016
- Causes of Molded Part Variation2013
- Effect of Gate Number on the Warpage in Injection Molding2012
- Processes and Process Selection2011
- Shrinkage behavior and optimization of injection molded parts studied by the taguchi methodPolymer Engineering & Science, 2001
- The Complete Injection Molding Process2000