Role of Crack‐Bridging Ligaments in the Cyclic Fatigue Behavior of Alumina
Authors:
- 1 November 1992
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 75 (11) , 2976-2984
Abstract
The cyclic fatigue crack growth behavior in two aluminas with different grain sizes and purities has been investigated using tapered cantilever beam specimens. The curves of load–crack opening displacement revealed a hysteretic loss behavior, in both aluminas, produced by frictional forces generated in the crack wake. From measurements of the specimen complinces it is concluded that the fatigue cracks in these materials were strongly bridged by both “frictional” and “elastic” load‐bearing ligaments. It is shown that the “elastic” contribution to the total crack‐bridging force is far greater than that produced by fristional sliding ligaments. The results support the view that cyclic loads produce degradation of the strength of the bridging ligaments. The effect of grain size and compressive loads on the magnitude of the bridging forces is discussed.Keywords
This publication has 17 references indexed in Scilit:
- Cyclic fatigue of ceramicsJournal of Materials Science, 1991
- Cyclic Fatigue from Frictional Degradation at Bridging Grains in AluminaJournal of the American Ceramic Society, 1991
- Cyclic Fatigue‐Crack Propagation in Magnesia‐Partially‐Stabilized Zirconia CeramicsJournal of the American Ceramic Society, 1990
- Cyclic Fatigue Behavior of an Alumina Ceramic with Crack‐Resistance CharacteristicsJournal of the American Ceramic Society, 1989
- Cyclic Fatigue Crack Propagation in Alumina under Direct Tension—Compression LoadingJournal of the American Ceramic Society, 1989
- Fatigue Crack Propagation in Transformation‐Toughened Zirconia CeramicJournal of the American Ceramic Society, 1987
- Static and Cyclic Fatigue Behavior of a Sintered Silicon Nitride at Room TemperatureJournal of the American Ceramic Society, 1987
- Fatigue strength of sintered Si3N4 under rotary bendingJournal of Materials Science Letters, 1987
- Fatigue strength of sintered Al2O3 under rotary bendingJournal of Materials Science Letters, 1986
- Cyclic fatigue of polycrystalline alumina in direct push-pullJournal of Materials Science, 1978