Development of Sulfur-Doped Graphitic Carbon Nitride for Hydrogen Evolution under Visible-Light Irradiation
Open Access
- 23 December 2022
- journal article
- research article
- Published by MDPI AG in Nanomaterials
- Vol. 13 (1) , 62
Abstract
Developing eco-friendly strategies to produce green fuel has attracted continuous and extensive attention. In this study, a novel gas-templating method was developed to prepare 2D porous S-doped g-C3N4 photocatalyst through simultaneous pyrolysis of urea (main g-C3N4 precursor) and ammonium sulfate (sulfur source and structure promoter). Different content of ammonium sulfate was examined to find the optimal synthesis conditions and to investigate the property-governed activity. The physicochemical properties of the obtained photocatalysts were analyzed by X-ray diffraction (XRD), field emission-scanning electron microscopy (FE-SEM), scanning transmission electron microscopy (STEM), specific surface area (BET) measurement, ultraviolet-visible light diffuse reflectance spectroscopy (UV/vis DRS), X-ray photoelectron spectroscopy (XPS), photoluminescence (PL) spectroscopy and reversed double-beam photo-acoustic spectroscopy (RDB-PAS). The as-prepared S-doped g-C3N4 photocatalysts were applied for photocatalytic H2 evolution under vis irradiation. The condition-dependent activity was probed to achieve the best photocatalytic performance. It was demonstrated that ammonium sulfate played a crucial role to achieve concurrently 2D morphology, controlled nanostructure, and S-doping of g-C3N4 in a one-pot process. The 2D nanoporous S-doped g-C3N4 of crumpled lamellar-like structure with large specific surface area (73.8 m2 g−1) and improved electron−hole separation showed a remarkable H2 generation rate, which was almost one order in magnitude higher than that of pristine g-C3N4. It has been found that though all properties are crucial for the overall photocatalytic performance, efficient doping is probably a key factor for high photocatalytic activity. Moreover, the photocatalysts exhibit significant stability during recycling. Accordingly, a significant potential of S-doped g-C3N4 has been revealed for practical use under natural solar radiation.Keywords
Funding Information
- Narodowa Agencja Wymiany Akademickiej (BPN/PPO/2021/1/00037, 2022/01/1/ST4/00026)
- Narodowe Centrum Nauki (BPN/PPO/2021/1/00037, 2022/01/1/ST4/00026)
This publication has 93 references indexed in Scilit:
- Solvent-free hydrothermal synthesis of anatase TiO2 nanoparticles with enhanced photocatalytic hydrogen production activityApplied Catalysis A: General, 2013
- Roles of Cocatalysts in Photocatalysis and PhotoelectrocatalysisAccounts of Chemical Research, 2013
- Two-Dimensional Crystals: Beyond GrapheneMaterials Express, 2011
- A systematic study of photocatalytic H2 production from propionic acid solution over Pt/TiO2 photocatalystInternational Journal of Energy Research, 2010
- On the Problem of Comparing Rates or Apparent Quantum Yields in Heterogeneous PhotocatalysisAngewandte Chemie International Edition, 2010
- Efficient production of hydrogen by photo-induced reforming of glycerol at ambient conditionsCatalysis Today, 2009
- Immobilization of noble metal nanoparticles on the surface of TiO2 by the sonochemical method: Photocatalytic production of hydrogen from an aqueous solution of ethanolUltrasonics Sonochemistry, 2007
- TiO2-assisted photocatalytic degradation of azo dyes in aqueous solution: kinetic and mechanistic investigationsApplied Catalysis B: Environment and Energy, 2004
- Flash photolysis observation of the absorption spectra of trapped positive holes and electrons in colloidal titanium dioxideThe Journal of Physical Chemistry, 1984
- Electrochemical Photolysis of Water at a Semiconductor ElectrodeNature, 1972