Soil mechanical stresses in high wheel load agricultural field traffic: a case study
- 12 September 2017
- journal article
- research article
- Published by CSIRO Publishing in Soil Research
- Vol. 56 (2) , 129-135
Abstract
Subsoil compaction is a serious long-term threat to soil functions. Only a few studies have quantified the mechanical stresses reaching deep subsoil layers for modern high wheel load machinery. In the present study we measured the vertical stresses in the tyre–soil contact area and at 0.3, 0.6 and 0.9 m depths of a sandy loam soil at field capacity water content. The soil was ploughed annually to a depth of 0.25 m and was tested in the spring following autumn ploughing but before secondary tillage. The machinery tested was a tractor–trailer system for slurry application with a total weight of 52 Mg. Wheel loads ranged from approximately 20 to 70 kN. The tyres were all radial ply with volumes ranging from 0.63 to 1.23 m3. The tyre inflation pressures were generally above those recommended by the manufacturer and ranged from 170 to 280 kPa. The stress distributions in the contact area were highly skewed. Across tyres, the maximum stress in the contact area correlated linearly with, but was much higher than, the mean ground pressure. For each of the three soil depths, the maximum stresses under the tyres were significantly correlated with the wheel load, but not with other loading characteristics. The data predict a 6.6-kPa increase in vertical stress at 0.9 m depth for each 1-Mg addition to the wheel load. The soil stress observations support a simple rule of thumb combining wheel load and inflation pressure in calculation of subsoil vertical stress. We measured vertical stresses up to 300, 100 and 45 kPa at soil depths of 0.3, 0.6 and 0.9 m respectively. Comparing these with the data in the literature regarding soil strength and measured compaction effects on the soil studied, we conclude that the traffic event investigated is likely to induce serious effects on soil properties and functions to a depth of at least 0.7 m.Keywords
This publication has 37 references indexed in Scilit:
- Rules of thumb for minimizing subsoil compactionSoil Use and Management, 2012
- Transmission of vertical stress in a real soil profile. Part I: Site description, evaluation of the Söhne model, and the effect of topsoil tillageSoil and Tillage Research, 2011
- Transmission of vertical stress in a real soil profile. Part II: Effect of tyre size, inflation pressure and wheel loadSoil and Tillage Research, 2011
- A note on the vertical stresses near the soil-tyre interfaceSoil and Tillage Research, 2010
- Mechanical behaviour of an undisturbed soil subjected to loadings: Effects of load and contact areaSoil and Tillage Research, 2007
- Soil compaction in cropping systemsSoil and Tillage Research, 2005
- Technical solutions to reduce the risk of subsoil compaction: effects of dual wheels, tandem wheels and tyre inflation pressure on stress propagation in soilSoil and Tillage Research, 2004
- USSR standards for agricultural mobile machinery: permissible influences on soils and methods to estimate contact pressure and stress at a depth of 0.5 mSoil and Tillage Research, 1994
- A method to predict the mechanical strength of agricultural soilsSoil and Tillage Research, 1991
- Crop and soil response to subsoil loosening, deep incorporation of phosphorus and potassium fertilizer and subsequent soil management on a range of soil types.: Part 2: Soil structural conditionsSoil Use and Management, 1987