Permit checking of overloaded customized transport vehicle based on serviceability limit state reliability of concrete bridges
Authors:
- 19 November 2020
- journal article
- research article
- Published by SAGE Publications in Advances in Structural Engineering
- Vol. 24 (5) , 884-896
Abstract
To increase the authorization efficiency of overloaded customized transport vehicle (CTV), a serviceability limit state (SLS) reliability based permit checking method for concrete bridges is proposed through the optimization towards critical load effect ratio. In this procedure, the SLS reliability of crack width and the SLS reliability of concrete stress in tensile region are analyzed for reinforced concrete (RC) and prestressed concrete (PC) structures, respectively. The durability requirements and a unified reliable level can be concentrated reflected by the optimized critical load effect ratio. The results show that it is unreasonable to take a uniform target reliability index for all routes in permit checking of CTV, a stricter authorization criterion should be adopted for a higher expected authorization frequency. For a specific route level, a fluctuant variation of critical load effect ratio can be found with the increasing of bridge span. By introducing an ultimate limit state (ULS) based safety checking procedure, it is found that the SLS based permit checking criterion is crucial and determinative for the authorization of CTV instead of the ULS.Keywords
Funding Information
- National Natural Science Foundation of China (51878058)
- Natural Science Basic Research Program of Shaanxi Province (2020JQ-665)
- National Key Research and Development Program of China (2019YFB1600702)
This publication has 40 references indexed in Scilit:
- Serviceability reliability analysis of prestressed concrete bridgesKSCE Journal of Civil Engineering, 2013
- Reliability of beams according to Eurocodes in serviceability limit stateEngineering Structures, 2012
- Serviceability Reliability of Reinforced Concrete Beams with Corroded ReinforcementJournal of Structural Engineering, 2009
- An overweight permit analysis system for bridge managementKSCE Journal of Civil Engineering, 2006
- Probability Based Assessment of Serviceability Limit States in Precast Concrete Bridges2004
- Calibration of reliability index of RC beams for serviceability limit state of maximum crack widthReliability Engineering & System Safety, 2002
- The JCSS probabilistic model codeStructural Safety, 1997
- Optimization of serviceability load combinations for structural steel beam designStructural Safety, 1996
- Serviceability Limit States: DeflectionJournal of Structural Engineering, 1986
- Structural Serviceability: Floor VibrationsJournal of Structural Engineering, 1984