An Evaluation of the Macro Damage on Metal Matrix Composites after High Velocity Impact
Author:
- 1 February 2007
- journal article
- Published by SAGE Publications in Journal of Composite Materials
- Vol. 41 (3) , 299-308
Abstract
The ballistic impact failures and damages on metal matrix composites reinforced by SiC and alumina are studied. AA 6063 aluminum alloy is reinforced with SiC and alumina particles in different sizes and percentages by casting method. Ballistic tests are carried out by two different projectile types, AP (armor piercing) 7.62 and 9 mm. The macrography of the craters and holes created by high velocity projectiles impact are analyzed by light and scanning electron microscopy studies.The projectile type strongly influences the damage formation. When the high velocity projectile (AP 7.62, 7.9 g, 710 m/s) impacts the 30% SiC or Al2O3 reinforced composite, it leads to deep craters and then a hole by passing the thickness of the composite target thoroughly. Brittle cracking on the target and on the reinforcing particles are also observed after impact. If this impacting carried out on the composite is relatively tough (i.e., having 15% SiC), swelling and petalling on the entrance and back sides of the hole are also created without any cracking or breaking. In case of impacting by a lower velocity projectile (9 mm, 7.47 g, 400 m/s) on the 15% SiC composite target, it can pass the thickness with or without its jacket. This projectile cannot pass the composites reinforced by 30% SiC and Al2O3. Besides some damages such as plastic deformation and craters occur on the projectile tip.Keywords
This publication has 8 references indexed in Scilit:
- Analyses of metallurgical behavior of Al–SiCp composites after ballistic impactsComposite Structures, 2004
- Numerical simulation of normal and oblique ballistic impact on ceramic composite armoursComposite Structures, 2004
- Failure and tribological behaviour of the AA5083 and AA6063 composites reinforced by SiC particles under ballistic impactComposites Part A: Applied Science and Manufacturing, 2003
- Mechanical behavior of cast SiCp-reinforced Al-4.5%Cu-1.5%Mg alloyMaterials Science and Engineering: A, 1996
- High strain rate deformation in particle reinforced metal matrix compositesActa Materialia, 1996
- The mechanical response of a 6061-T6 A1/A12O3 metal matrix composite at high rates of deformationActa Metallurgica et Materialia, 1995
- Effects of Heat Treatment and Reinforcement Size on Reinforcement Fracture during Tension Testing of a SiCp Discontinuously Reinforced Aluminum AlloyMetallurgical Transactions A, 1993
- Micromechanical fracture process of SiC-particle-reinforced aluminium alloy 6061-T6 metal matrix compositesMaterials Science and Engineering: A, 1992