Energy absorbing properties of a steel profile made of dual phase steel
Authors:
Open Access
- 7 September 2018
- journal article
- research article
- Published by EDP Sciences in EPJ Web of Conferences
- Vol. 183, 01062
Abstract
Three point bending tests were carried out using a drop tower testing machine. Profile were made of 2 mm dual phase steel. Material was characterized at wide range of strain rates to calibrate Rusinek-Klepaczko constitutive model. Finally, experimental results were compared with numerical predictions obtained using finite element method.Keywords
This publication has 8 references indexed in Scilit:
- Application of optical field analysis of tensile tests for calibration of the Rusinek–Klepaczko constitutive relation of Ti6Al4V titanium alloyMaterials & Design, 2015
- Effects of pre-fatigue on the strain localization during tensile tests of DP 500 steel at low and high strain ratesThe Journal of Strain Analysis for Engineering Design, 2015
- Analysis of the Impact of the Frequency Range of the Tensometer Bridge and Projectile Geometry on the Results of Measurements by the Split Hopkinson Pressure Bar MethodMetrology and Measurement Systems, 2013
- Mechanical behaviour of dual-phase high-strength steel under high strain rate tensile loadingMaterials Science and Engineering: A, 2013
- Analysis of thermo-visco-plastic behaviour of six high strength steelsMaterials & Design (1980-2015), 2009
- Cyclic Deformation of Advanced High-Strength Steels: Mechanical Behavior and Microstructural AnalysisMetallurgical and Materials Transactions A, 2009
- Shear testing of a sheet steel at wide range of strain rates and a constitutive relation with strain-rate and temperature dependence of the flow stressInternational Journal of Plasticity, 2001
- A direct-tension split Hopkinson bar for high strain-rate testingExperimental Mechanics, 1991