The Effects of Residual Tritium on Air-Detritiation Dryer Performance
Authors:
- 1 March 1992
- journal article
- research article
- Published by Taylor & Francis in Fusion Technology
- Vol. 21 (2P2) , 599-603
Abstract
The effects on the performance of an air-detritiation dryer (ADD) of inlet-gas humidity and residual tritiated water (HTO) left on the desiccant following regeneration were demonstrated. Residual HTO significantly reduced the detritiation factor (DFSP) of an ADD from clean-bed values. In addition, HTO/H2O separation occurred in the ADD, with H2O leading HTO. HTO roll-up may also have occurred. Finally, an increase in the inlet-gas humidity at constant inlet HTO concentration decreased the DFSP while increasing the humidity-reduction factor (HRFSP).Keywords
This publication has 5 references indexed in Scilit:
- Early Operating Experience with the Tritium Systems Test Assembly Tritium Waste Treatment SystemFusion Technology, 1985
- Removal of Tritiated Water Vapor by Adsorption on Molecular Sieves - Effects of Co-Existing H2OFusion Technology, 1985
- Desorption Rate of Adsorbed Tritiated Water from Molecular Sieve 5A by Exchange with Environmental Water VaporJournal of Nuclear Science and Technology, 1982
- Distribution Equilibrium of Tritium between Adsorbed Water on Molecular Sieve 5A and Environmental WaterJournal of Nuclear Science and Technology, 1980
- Removal of Tritiated Water Vapor by AdsorptionJournal of Nuclear Science and Technology, 1976