Low-Noise CMOS single-photon avalanche diodes with 32 ns dead time
Authors:
- 1 January 2007
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 19308876,p. 362-365
Abstract
The implementation of single-photon avalanche diode detectors (SPAD) in a standard high voltage 0.7-mum CMOS technology is presented. Two different device structures, combined with integrated quenching circuits, have been fabricated and successfully tested. A novel biasing scheme is proposed allowing the reduction of afterpulsing effect and the decrease of minimum device-to-device distance. Good noise performance is obtained for the 100 mum2 active area device where over 50% of the population has a dark count rate below lOOcps and afterpulsing lower than 0.3% with a 4-V excess bias and a 32-ns dead time. The peak photon detection probability is about 30%, while the overall system, upper limit, for the time resolution is 144 ps.Keywords
This publication has 7 references indexed in Scilit:
- Design and characterization of a CMOS 3-D image sensor based on single photon avalanche diodesIEEE Journal of Solid-State Circuits, 2005
- Monolithic CMOS detector module for photon counting and picosecond timing2004
- Fast fluorescence lifetime imaging of calcium in living cellsJournal of Biomedical Optics, 2004
- Characterization of Geiger mode avalanche photodiodes for fluorescence decay measurements2002
- Time-resolved fluorescence imaging in biology and medicineJournal of Physics D: Applied Physics, 2002
- Molecular Dynamics in Living Cells Observed by Fluorescence Correlation Spectroscopy with One- and Two-Photon ExcitationBiophysical Journal, 1999
- Avalanche photodiodes and quenching circuits for single-photon detectionApplied Optics, 1996