Improved Method for Direct Black-Box Arc Parameter Determination and Model Validation
- 9 January 2014
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 29 (2) , 580-588
Abstract
Black-box models are a valuable tool to simulate dynamic arc-network interactions, such as those that occur during fault current interruption in ac or HVDC circuit breakers. However, accurate determination of characteristic arc parameters from voltage and current measurements is very challenging. This paper aims to improve the accuracy in arc characterization. A new arbitrary current source is used to simplify arc parameter determination through a more complex current waveform, for example, a series of staircase-like increasing steps. With this, the stationary and transient arc characteristics can be measured independently from each other. Therefore, current steps are well suited to: 1) validate the choice of a specific black-box model and 2) determine the arc parameters of the chosen model with higher accuracy. In principle, the source is also well suited to fill a table of the arc voltage response U, U̇ at various current levels and slopes I, İ. Thus, it would be possible to characterize arcs independent of any black-box model, but it would not be well suited to compare different arcs. Therefore, this paper focuses on an improved black-box parameter determination and the experimental validation of the Schwarz model, with P and τ being free functions of g.Keywords
This publication has 13 references indexed in Scilit:
- Linking a physical arc model with a black box arc model and verificationIEEE Transactions on Dielectrics and Electrical Insulation, 2011
- HVDC Circuit Breakers: A Review Identifying Future Research NeedsIEEE Transactions on Power Delivery, 2011
- Approximation Model-Assisted Optimization Technique to Improve Capacitive Current Interrupting Performance of Gas Circuit BreakerIEEE Transactions on Magnetics, 2009
- Self-consistent radiation-based simulation of electric arcs: II. Application to gas circuit breakersJournal of Physics D: Applied Physics, 2008
- An integral arc model for ablation controlled arcs based on CFD simulationsJournal of Physics D: Applied Physics, 2006
- Current interruption limit and resistance of the self-similar electric arcJournal of Applied Physics, 2005
- Optimization of high-voltage self-blast interrupters by gas flow and electric field computationsIEEE Transactions on Power Delivery, 2003
- Evaluation of high-voltage circuit breaker performance with a new validated arc modelIEE Proceedings - Generation, Transmission and Distribution, 2000
- A method of determining the dynamic characteristics of electric arcsProceedings of the IEE - Part IV: Institution Monographs, 1954
- Beiträge zur Theorie des statischen und des dynamischen LichtbogensElectrical Engineering, 1943