Evaluation of degree of conversion, rate of cure, microhardness, depth of cure, and contraction stress of new nanohybrid composites containing pre-polymerized spherical filler
- 28 November 2020
- journal article
- research article
- Published by Springer Nature in Journal of Materials Science: Materials in Medicine
- Vol. 31 (12) , 1-11
Abstract
The aim of the present study was to characterize nanohybrid and nanofilled composites in terms of degree of conversion (DC), rate of cure (RC), microhardness (Vickers hardness number; VHN), depth of cure, and contraction stress (CS). Ceram.X® universal- A3, duo enamel E2, and duo dentin D3 composites were compared to Tetric EvoCeram® and FiltekTMSupreme XTE composites of equivalent dentin and enamel shades under a 40 s photopolymerization protocol. DC was measured by infrared spectroscopy, calculating RC from the kinetic curve. Top and bottom VHN were determined using a Vickers indenter, and bottom/top surface ratio (Vickers hardness ratio; VHR) calculated. CS vs. time was assessed by a universal testing machine and normalized for the specimen bonding area. All materials showed DC < 60%, Ceram.X® composites reaching higher values than the other composites of corresponding shades. RC at 5 s of photopolymerization was always higher than that at 10 s. All the Ceram.X® composites and the lighter-shaded Tetric EvoCeram® and FiltekTMSupreme XTE composites reached the RC plateau after 25 s, the remaining materials showed a slower kinetic trend. Tetric EvoCeram® and FiltekTMSupreme XTE composites displayed the softest and the hardest surfaces, respectively. Differently from darker-shaded materials, the universal and the three enamel-shaded composites resulted optimally cured (VHR > 80%). The tested composites differed in CS both during and after light cure, Tetric EvoCeram® and FiltekTMSupreme XTE composites displaying the highest and the lowest CS, respectively. Only the Ceram.X® universal-A3 reached a CS plateau value. The tested composites exhibited material-dependent chemo-mechanical properties. Increasing the curing time and/or reducing the composite layer thickness for dentin-shaded composites appears advisable.Keywords
This publication has 47 references indexed in Scilit:
- Resin based restorative dental materials: characteristics and future perspectivesJapanese Dental Science Review, 2019
- Do Nanofilled/Nanohybrid Composites Allow for Better Clinical Performance of Direct Restorations Than Traditional Microhybrid Composites? A Systematic ReviewOperative Dentistry, 2018
- Effects of Filler Size on the Mechanical Properties of Polymer-filled Dental Composites: A Review of Recent DevelopmentsJournal of Physical Science, 2018
- Filler characteristics of modern dental resin composites and their influence on physico-mechanical propertiesDental Materials, 2016
- Resin composite—State of the artDental Materials, 2011
- Recent Advances and Developments in Composite Dental Restorative MaterialsJournal of Dental Research, 2010
- Properties of Hybrid Resin Composite Systems Containing Prepolymerized Filler ParticlesOperative Dentistry, 2009
- Influence of the distance of the curing light source and composite shade on hardness of two compositesJournal of Applied Oral Science, 2007
- An overview of treatment considerations for esthetic restorations: A review of the literatureThe Journal of Prosthetic Dentistry, 2006
- The effect of filler loading and morphology on the mechanical properties of contemporary compositesThe Journal of Prosthetic Dentistry, 2002