Defect Inspection of Flip Chip Solder Bumps Using an Ultrasonic Transducer
Open Access
- 27 November 2013
- Vol. 13 (12) , 16281-16291
Abstract
Surface mount technology has spurred a rapid decrease in the size of electronic packages, where solder bump inspection of surface mount packages is crucial in the electronics manufacturing industry. In this study we demonstrate the feasibility of using a 230 MHz ultrasonic transducer for nondestructive flip chip testing. The reflected time domain signal was captured when the transducer scanning the flip chip, and the image of the flip chip was generated by scanning acoustic microscopy. Normalized cross-correlation was used to locate the center of solder bumps for segmenting the flip chip image. Then five features were extracted from the signals and images. The support vector machine was adopted to process the five features for classification and recognition. The results show the feasibility of this approach with high recognition rate, proving that defect inspection of flip chip solder bumps using the ultrasonic transducer has high potential in microelectronics packaging.Keywords
This publication has 22 references indexed in Scilit:
- Ultrasonic Array for Obstacle Detection Based on CDMA with Kasami CodesSensors, 2011
- A novel approach for flip chip solder joint inspection based on pulsed phase thermographyNDT & E International, 2011
- Automated inspection and classification of flip-chip-contacts using scanning acoustic microscopyMicroelectronics Reliability, 2010
- A Neurofuzzy Method for the Evaluation of Soldering Global Quality IndexIEEE Transactions on Industrial Informatics, 2009
- Effects of soft beam energy on the microstructure of Pb37Sn, Au20Sn, and Sn3.5Ag0.5Cu solder joints in lensed-SM-fiber to laser-diode-affixing applicationOptics and Lasers in Engineering, 2007
- Investigation of void nucleation and propagation during electromigration of flip-chip solder joints using x-ray microscopyApplied Physics Letters, 2006
- Electrical characteristics for Sn-Ag-Cu solder bump with Ti/Ni/Cu under-bump metallization after temperature cycling testsJournal of Electronic Materials, 2006
- Composite lead-free electronic soldersJournal of Materials Science: Materials in Electronics, 2006
- Application of Neural Networks in Optical Inspection and Classification of Solder Joints in Surface Mount TechnologyIEEE Transactions on Industrial Informatics, 2006
- Micromechanical modeling of damage due to particle cracking in reinforced metalsComputational Materials Science, 1999