Microfluidic Fabrication Techniques for High-Pressure Testing of Microscale Supercritical CO2 Foam Transport in Fractured Unconventional Reservoirs
- 2 July 2020
- journal article
- research article
- Published by MyJove Corporation in Journal of Visualized Experiments
- No. 161,p. e61369
Abstract
Pressure limitations of many microfluidic platforms have been a significant challenge in microfluidic experimental studies of fractured media. As a result, these platforms have not been fully exploited for direct observation of high-pressure transport in fractures. This work introduces microfluidic platforms that enable direct observation of multiphase flow in devices featuring surrogate permeable media and fractured systems. Such platforms provide a pathway to address important and timely questions such as those related to CO2 capture, utilization and storage. This work provides a detailed description of the fabrication techniques and an experimental setup that may serve to analyze the behavior of supercritical CO2 (scCO2) foam, its structure and stability. Such studies provide important insights regarding enhanced oil recovery processes and the role of hydraulic fractures in resource recovery from unconventional reservoirs. This work presents a comparative study of microfluidic devices developed using two different techniques: photolithography/wet-etching/thermal-bonding versus Selective Laser-induced Etching. Both techniques result in devices that are chemically and physically resistant and tolerant of high pressure and temperature conditions that correspond to subsurface systems of interest. Both techniques provide pathways to high-precision etched microchannels and capable lab-on-chip devices. Photolithography/wet-etching, however, enables fabrication of complex channel networks with complex geometries, which would be a challenging task for laser etching techniques. This work summarizes a step-by-step photolithography, wet-etching and glass thermal-bonding protocol and, presents representative observations of foam transport with relevance to oil recovery from unconventional tight and shale formations. Finally, this work describes the use of a high-resolution monochromatic sensor to observe scCO2 foam behavior where the entirety of the permeable medium is observed simultaneously while preserving the resolution needed to resolve features as small as 10 µm.Keywords
This publication has 25 references indexed in Scilit:
- Development of highly stable lamella using polyelectrolyte complex nanoparticles: An environmentally friendly scCO2 foam injection method for CO2 utilization using EORFuel, 2020
- 3D-printed glass microfluidics for fluid dynamics and rheologyCurrent Opinion in Colloid & Interface Science, 2019
- Enhancement of storage capacity of CO2 in megaporous saline aquifers using nanoparticle-stabilized CO2 foamInternational Journal of Greenhouse Gas Control, 2019
- An experimental investigation of nanoparticle-stabilized CO 2 foam used in enhanced oil recoveryFuel, 2016
- Mixing in a three‐phase system: Enhanced production of oil‐wet reservoirs by CO 2 injectionGeophysical Research Letters, 2016
- Discrete fracture modeling using Centroidal Voronoi grid for simulation of shale gas plays with coupled nonlinear physicsFuel, 2016
- Pore‐scale mechanisms for the enhancement of mixing in unsaturated porous media and implications for chemical reactionsGeophysical Research Letters, 2015
- Shale gas and non-aqueous fracturing fluids: Opportunities and challenges for supercritical CO2Applied Energy, 2015
- CO2 as a fracturing fluid: Potential for commercial-scale shale gas production and CO2 sequestrationEnergy Procedia, 2014
- Fabrication, mechanical testing and application of high-pressure glass microreactor chipsChemical Engineering Journal, 2007