Effect of fibre orientation on damage resistance of composite laminates
- 23 December 2019
- journal article
- research article
- Published by Taylor & Francis in International Journal of Crashworthiness
- Vol. 26 (3) , 270-282
Abstract
The present study deals with the behaviour of angle ply composite laminates subjected to low velocity impact. The laminates were prepared by E-glass fibres as reinforcement and epoxy as resin. Experiments were performed on these laminates by using low velocity drop weight set-up machine at three energy levels produced by using two masses. At energy level it was noticed that, [0/90]s laminate was most damage resistant and [0/15]s laminate was least resistant while the contact duration of impactor on laminate(s) was found to be sensitive to mass level. Finite Element (FE) analysis was performed to quantify the damage in laminates and investigate energy absorbed in intra-layer failure modes. During the post-processing FE analysis helps to mark the critical load points on the load-displacement history and quantification of distinct failure modes. The size of delamination profile was seen to be governed by fibre orientation and inter-laminar shear stresses at the interface.Keywords
This publication has 51 references indexed in Scilit:
- Impact damage resistance of sandwich structure subjected to low velocity impactJournal of Materials Processing Technology, 2008
- Comparison of the load/displacement and energy absorption performance of round and square AA6061-T6 extrusions under a cutting deformation modeInternational Journal of Crashworthiness, 2007
- An engineering solution for mesh size effects in the simulation of delamination using cohesive zone modelsEngineering Fracture Mechanics, 2007
- Physically based non-linear stress–strain relations for the inter-fibre fracture analysis of FRP laminatesComposites Science and Technology, 2007
- An experimental methodology for evaluating survivability of an aeronautical construction from composite materials: An overviewInternational Journal of Crashworthiness, 2007
- Modeling of impacts on composite structuresComposite Structures, 2001
- Effects of fiber length and fiber orientation distributions on the tensile strength of short-fiber-reinforced polymersComposites Science and Technology, 1996
- Measurement of mixed-mode delamination fracture toughness of unidirectional glass/epoxy composites with mixed-mode bending apparatusComposites Science and Technology, 1996
- Delamination fracture: Effect of fiber orientation on fracture of a continuous fiber composite laminateEngineering Fracture Mechanics, 1992
- A Fatigue Failure Criterion for Fiber Reinforced MaterialsJournal of Composite Materials, 1973