Optimisation of Synchronous Grouting Mix Ratio for Shield Tunnels
Open Access
- 11 May 2024
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 14 (10) , 4098
Abstract
During shield construction in underground spaces, synchronous grouting slurry is poured between the surrounding rock and tunnel lining to ensure stability. For synchronous grouting slurries, few studies have investigated the relationship between the rheological parameters and physical properties, grout-segregation mechanism, and anti-segregation performance. Therefore, we explored the relationships between the slurry rheological parameters, segregation rate, and bleeding rate. Cement, sand, fly ash, and bentonite were used to prepare the slurry, and the effects of different polycarboxylate water-reducing agents and dispersible latex powder dosages were studied. The rheological parameters of 16 groups of uniformly designed slurries were tested, and the data were fit using the Herschel–Bulkley model. The optimal mix ratio lowered the slurry segregation rate, and its rheological behaviour was consistent with the Herschel–Bulkley fluid characteristics. High-yield-shear-stress synchronous grouting slurries with high and low viscosity coefficients were less likely to bleed and segregate, respectively. The optimised slurry fluidity, 3 h bleeding rate, 24 h bleeding rate, segregation rate, coagulation time, and 28 days compressive strength were 257.5 mm, 0.71%, 0.36%, 3.1%, 6.7 h, and 2.61 MPa, respectively, which meet the requirements of a synchronous grouting slurry of shield tunnels for sufficiently preventing soil disturbance and deformation in areas surrounding underground construction sites.Keywords
Funding Information
- Key Research & Development Program of Guangxi (AB23026091)
This publication has 19 references indexed in Scilit:
- Effects of fly and coal bottom ash ratio on backfill material performanceConstruction and Building Materials, 2022
- Influence of water to binder ratio on the rheology and structural Build-up of Alkali-Activated Slag/Fly ash mixturesConstruction and Building Materials, 2020
- 3D printed concrete for large-scale buildings: An overview of rheology, printing parameters, chemical admixtures, reinforcements, and economic and environmental prospectsJournal of Building Engineering, 2020
- Rheology of fly ash-based geopolymer: Effect of NaOH concentrationConstruction and Building Materials, 2019
- Printability region for 3D concrete printing using slump and slump flow testComposites Part B: Engineering, 2019
- How does adsorption behavior of polycarboxylate superplasticizer effect rheology and flowability of cement paste with polypropylene fiber?Cement and Concrete Composites, 2019
- Influence of the alkaline solution and temperature on the rheology and reactivity of alkali-activated fly ash pastesCement and Concrete Composites, 2019
- Axisymmetric viscoplastic dambreaks and the slump testJournal of Non-Newtonian Fluid Mechanics, 2018
- Rheological properties and the air content in fresh concrete for self compacting high performance concreteConstruction and Building Materials, 2015
- The interrelationship between surface chemistry and rheology in alkali activated slag pasteConstruction and Building Materials, 2014